LED effect light EUROLITE GoFlow 100, 100W, model 51918591

EUROLITE GoFlow 100 is a compact 100W LED effect light designed for stage, club and event lighting. The fixture creates dynamic moving-beam effects and colorful patterns suitable for accenting performances, DJ setups and small venues. Its compact housing and low power consumption make it suitable for temporary installations where portability and straightforward setup are important.

Advantages

The unit combines a bright 100W LED source with efficient optics to deliver vivid effects while minimizing heat and power draw. Its compact footprint and lightweight construction simplify mounting and transport. Controls are intuitive, allowing for manual operation or integration into a lighting rig. Built for event use, the housing provides stable operation during continuous shows.

Suitable for

• Small stages and theater fringe performances
• Club and bar lighting for DJs and music events
• Corporate events, presentations and product launches
• Private parties and weddings in smaller venues
• Portable setups for mobile entertainers and AV rental

Key specifications

• Light source: 100W LED
• Effect type: moving beam and pattern projection
• Power consumption: nominal 100 watts
• Mounting options: bracket for truss or stand mounting
• Control: onboard controls with DMX compatibility
• Cooling: passive or low-noise forced cooling for continuous use
• Housing: compact, transport-friendly enclosure

How to use

Install the fixture on a stable stand or truss using the supplied mounting bracket and secure fastenings. Connect the unit to mains power and select the desired operating mode via the front panel controls or DMX interface. Configure modes, speeds and colors according to the scene requirements. Position the fixture so projected beams and patterns achieve the intended coverage without obstructing audience sightlines. Allow adequate ventilation around the unit during prolonged operation.

Usage recommendations

For reliable operation, use a dedicated circuit and avoid daisy-chaining too many high-draw devices on the same supply. Check DMX addressing before showtime and run a short test sequence to verify effect timing and safety of mounting hardware.