Roller shutter radio controller FF F&Wave FW-STR1P-P, multifunction, 0.6 A, 85–265 V AC/DC, for Ø60 mounting box

Multifunction radio controller FF F&Wave FW-STR1P-P is designed for in-wall control of roller shutters and blinds. The compact module fits into a Ø60 mm flush-mounting box and supports remote up, down and stop commands. It operates from a wide supply range of 85–265 V AC/DC and delivers up to 0.6 A output current, making it suitable for low-power drive motors and lightweight shading systems while integrating with compatible F&Wave radio networks and common home automation setups.

Advantages

The unit's small form factor allows installation behind a wall switch or in confined electrical boxes, preserving the interior look without visible controllers. Wide voltage compatibility enables use in regions with differing mains standards and in installations where DC supply is required. Radio control provides wireless operation and reduces the need for additional wiring, while the dedicated up/down/stop functions give direct control over shutter and blind movement. Built-in protection and defined current rating help prevent overload of small motors.

Suitable for

• Control of roller shutters and window blinds with low-power drive motors
• Retrofit installations behind existing switch plates in homes and apartments
• Integration with F&Wave-compatible radio control systems and simple smart home setups
• Locations requiring a compact module to fit into a Ø60 mm flush-mounting box

Key specifications

• Operating voltage range: 85–265 V AC/DC
• Maximum output current: 0.6 A
• Mounting requirement: fits Ø60 mm flush-mounting box
• Control functions: up, down and stop (radio remote control)
• Application: roller shutters and blinds

How to use

Install the controller into a Ø60 mm flush-mounting box and connect supply and motor wires according to the manufacturer's wiring diagram. Pair the module with compatible F&Wave radio transmitters or gateway following the pairing procedure provided with the control system. Use the paired radio control to issue up, down and stop commands; the module will handle the motor switching within its rated current. Ensure correct polarity and secure connections before restoring mains power. For safety, switch off the circuit breaker while performing installation.

Usage recommendations

Use this controller with motors and shutters that do not exceed the 0.6 A output current rating. For heavier loads, select a device with a higher current capacity. Verify compatibility with your F&Wave radio network and follow local electrical codes for in-wall installations. Periodically inspect wiring and mounting to maintain reliable operation.