Screw & wall plug kit FISCHER 535483 — 50 mm length, for brick and concrete, drill Ø 10 mm, min depth 60 mm, 2 pcs

FISCHER 535483 is a screw and wall plug kit engineered for secure medium-duty fixing in brick and concrete. The kit includes two matched plugs and screws with a plug length of 50 mm, designed to work with a 10 mm drill bit and a recommended minimum drill depth of 60 mm. Supplied in blister packaging, this kit is intended for construction and renovation tasks where a reliable mechanical anchor is required for fixtures and fittings.

Advantages

The matched screw and plug combination ensures a consistent fit and reliable load transfer in solid masonry substrates. A 50 mm plug length provides adequate embedment depth for medium-duty anchors while the specification for a 10 mm drill hole and 60 mm minimum depth helps achieve correct installation geometry. Blister packaging keeps components together and visible for quick identification on-site.

Suitable for

• Fixing shelves and cabinets to brick or concrete walls
• Securing light to medium-weight fixtures such as handrails and brackets
• General renovation tasks requiring mechanical anchors in masonry
• Temporary or permanent installations in solid substrates

Key specifications

• Plug length: 50 mm
• Drill bit diameter required: 10 mm
• Minimum drill hole depth: 60 mm
• Suitable substrate: brick and concrete
• Quantity: 2 pieces per pack
• Packaging type: blister

How to use

Drill a clean hole of 10 mm diameter to at least 60 mm depth in the brick or concrete substrate. Remove dust from the hole using a brush or compressed air. Insert the wall plug fully into the hole until flush with the surface, position the fixture, and drive the matching screw into the plug until the fixture is securely clamped. Avoid over-tightening to prevent deformation of the plug or damage to the substrate.

Usage recommendations

Verify substrate condition before installation and use appropriate drill bits for masonry. For heavy loads or hollow substrates, select an anchor system specifically rated for those conditions. Store the kit in a dry place to prevent corrosion of the screws.