Screw Anchor Fischer 564610 50 pcs 95 mm M8 Steel

The Fischer screw anchor FAZ II Plus (Fischer 564610) is a steel expansion anchor designed for heavy-duty fastening in concrete and masonry. With an 8 mm diameter and 95 mm length, this pack of 50 anchors is suitable for securing railings, cable trays and consoles in cracked and non-cracked concrete as well as in solid masonry. The anchor is made of steel and is intended for use where high tensile strengths and reliable seismic and fire performance are required.

Advantages

The FAZ II Plus enables faster, easier installation by eliminating the need to clean drill holes for sizes M8–M24. It holds multiple approvals for a wide range of base materials (concrete classes C12/15–C80/90, steel fiber concrete, and solid sand-lime brick), increasing possible applications. Updated ETA assessment provides higher tensile strengths so fewer anchors or fixing points may be required. Documented performance under fire (ETA, RWS, ZTV, ETK) and the option to adjust anchorage depth millimetre-precisely support reliable load-bearing behaviour. The anchor also absorbs high seismic loads (performance category C1), with or without the FFD filling disc.

Suitable for

• Anchoring railings and guardrails
• Fixing cable trays and electrical conduits
• Mounting consoles, brackets and structural supports
• Heavy-duty fixings in cracked and non-cracked concrete

Key specifications

• Brand: FISCHER
• Model / MPN: 564610
• Type: FAZ II Plus screw anchor (steel expansion anchor)
• Material: Steel
• Diameter: M8 (8 mm)
• Length: 95 mm
• Drill hole diameter: 8 mm
• Pack quantity: 50 pcs
• Suitable substrates: Concrete (C12/15–C80/90), steel fiber concrete, solid sand-lime brick
• Approvals: ETA and additional test reports for fire and seismic performance

How to use

Drill the hole with the specified 8 mm drill bit to the required depth, then insert the FAZ II Plus anchor either as a through-fixing or pre-positioned fixing. Tighten the bolt to the prescribed installation torque so the cone pulls into the expansion sleeve and secures against the drill hole wall. For stand-off applications use the long thread available on the anchor. For series installation use the recommended setting tools (FABS or FA-ST II) to ensure consistent torque and correct setting. If seismic requirements apply, consider using the FFD filling disc when specified by the approval.

Usage recommendations

Follow the product approval and installation torque values exactly and use the correct drill bit and setting tools for series installation. Do not omit substrate checks—confirm concrete class and condition (cracked or non-cracked) before selecting anchor spacing and embedment depth.