Screw Anchor Fischer 564627 20 pcs 148 mm for Brick Concrete

The Fischer screw anchor (MPN 564627) is a steel bolt anchor designed for high-strength fixings in brick and concrete. With an M16 thread, 1.6 cm diameter and 148 mm length, this pack of 20 anchors is suitable for securing railings, cable trays, consoles and other fixtures where high tensile strength and reliable load transfer are required. The FAZ II Plus design allows immediate loading after installation and supports use in cracked concrete and applications with dynamic loads when used according to approvals.

Advantages

The FAZ II Plus-type screw anchor offers faster and easier installation because drill-hole cleaning is not required for diameters M8–M24, reducing installation time on site. Multiple approvals for substrates such as concrete (C12/15–C80/90), steel fiber concrete and solid sand-lime brick broaden its range of applications. Updated ETA assessments increase allowable tensile values, often reducing the number of anchors needed. For diameters M16–M24 the ETA confirms suitability for dynamic loads, and the anchor provides an immediately loadable fixing point suitable for low cycle dynamic applications when installed correctly. Additional assessments and test reports verify performance in fire, and an independent report confirms an expected service life up to 120 years for diameters M10–M16. The anchor also accepts high seismic loads (performance categories C1 and C2) for M10–M24 and allows millimetre-accurate adjustment through variable anchorage depths.

Suitable for

• Anchoring railings and balustrades
• Fixing cable trays and conduit systems
• Mounting consoles and supports
• Applications with dynamic loads (e.g., conveyor belts, pumps, lifting platforms) — where approved
• Installations in brick and concrete substrates

Key specifications

• Brand: FISCHER
• Model / MPN: 564627
• Type: Screw bolt anchor (FAZ II Plus design)
• Thread / diameter: M16 / 1.6 cm
• Length: 148 mm
• Material: Steel
• Pack quantity: 20 pieces
• Suitable substrates: Concrete (C12/15–C80/90), steel fiber concrete, solid sand-lime brick

How to use

Drill the correct diameter and depth for the M16 anchor into the substrate. For pre-positioned or push-through installation place the anchor and apply the specified installation torque. As torque is applied the cone bolt pulls into the expansion sleeve, expanding it against the drill-hole wall; the anchor reaches its approval-compliant set position when the preset torque is achieved. For series installation, use the FABS or FA-ST II setting tools to ensure consistent setting. For dynamic applications, use the recommended dynamic set and fill it with a suitable injection mortar (compressive strength ≥ 50 N/mm², e.g., FIS V Plus, FIS EM Plus, FIS HB or FIS SB) after installation. If seismic requirements apply, consider using the filling disc FFD to close the annular gap.

Usage recommendations

Use anchors according to the relevant ETA and national approvals; verify substrate condition and required embedment depth before installation. Do not exceed approved loads; follow the manufacturer's torque and setting tool recommendations. For dynamic or seismic applications, follow the specified additional measures (dynamic set, injection mortar, filling disc) and the supporting test reports to ensure compliance.