FISCHER FAZ II Plus screw anchor M10 zinc plated steel, Ø10 mm, L95 mm, pack of 50

The FISCHER FAZ II Plus screw anchor M10 is a zinc-plated steel bolt anchor with a 10 mm diameter and 95 mm length, supplied in a pack of 50. It is designed for secure fixing of structural and non-structural elements in concrete and masonry and requires a 10 mm drill hole. The anchor offers variable anchorage depths and is suitable for both pre-positioned and push-through installation methods.

Advantages

The FAZ II Plus GS combines a proven expansion clip with a pre-assembled large washer to deliver reliable load transfer into cracked concrete. Its zinc-plated steel construction and updated assessment (ETA) increase tensile load capacities, allowing fewer fixings and smaller anchor plates in many applications. The design permits quicker assembly without drill hole cleaning for sizes M8–M24 and numerous approvals extend its applicability to various substrates. Independent testing confirms durability up to 120 years for certain sizes.

Suitable for

• Fixing steel fixtures and components with elongated/slotted holes
• Structural and non-structural anchoring in concrete and solid masonry
• Applications requiring higher tensile loads and seismic performance (M10 range)
• Projects where variable anchorage depth and millimetre-accurate adjustment are needed

Когда может не подойти

The FAZ II Plus M10 is not intended for use in substrates or conditions outside its approvals; performance can be reduced in weak, hollow, or unsuitable base materials not covered by the product certificates. For applications requiring stainless corrosion resistance or specific chemical resistance, the zinc-plated version may be insufficient and a different material or coating should be selected.

Key specifications

• Anchor type: screw/bolt anchor with expansion sleeve
• Material: zinc-plated steel
• Thread/nominal size: M10
• Anchor diameter: 10 mm
• Overall length: 95 mm
• Pack quantity: 50 pieces
• Drill hole diameter required: 10 mm
• Installation types: pre-positioned and push-through (stand-off under certain conditions)
• Variable anchorage depths for millimetre-accurate adjustment

How to use

Drill a 10 mm hole to the required depth in accordance with the substrate and the chosen anchorage depth. Depending on the installation method, insert the anchor either through the fixture (push-through) or position it in the hole before placing the fixture (pre-positioned). Apply the specified installation torque; as the cone bolt is tightened, it is pulled into the expansion sleeve which expands against the drill hole wall. Tighten until the preset torque is reached and the anchor is set in line with the approval.

What to consider before purchase

• Ensure the substrate (concrete grade or masonry) is covered by the product approvals and suitable for expansion anchors
• Verify that zinc-plated steel meets required corrosion resistance for the environment
• Confirm required drill diameter (10 mm) and available hole depth for desired anchorage
• Check required load capacities and whether M10 performance matches structural needs

Usage recommendations

Follow the manufacturer’s installation torque values and approved installation procedures. Use the anchor only in substrates and conditions specified by the product approvals, and select a corrosion class appropriate for the installation environment.