Hydraulic Car Jack GEKO 5T model K00123 — 5-ton lifting capacity

Hydraulic car jack GEKO 5T model K00123 is a workshop-grade floor jack designed for lifting vehicles and heavy equipment with a rated capacity of five tonnes. The unit uses a hydraulic mechanism to deliver smooth, controlled lifting and stable support during repairs, maintenance and tire changes. Its compact footprint and low-profile saddle make it suitable for use in garages, service stations and roadside assistance situations where a high-capacity, portable jack is needed.

Advantages

The GEKO 5T hydraulic jack provides reliable lifting performance with a robust steel construction and a hydraulic system engineered for steady, incremental raising. It offers a combination of high load capacity and compact design, enabling easier storage and handling compared with larger lifting equipment. The low-profile approach height allows access under lowered vehicle sills, while the wide base and reinforced frame ensure stability during operation. Controls are simple to operate, supporting precise positioning and safe lowering.

Suitable for

• Lifting passenger cars, light commercial vehicles and some small vans for maintenance
• Tire replacement and underbody inspections in workshops and service stations
• Mobile roadside assistance and emergency vehicle recovery where a portable high-capacity jack is required
• General garage use for brake work, suspension servicing and component replacement

Key specifications

• Lifting capacity: 5 tonnes
• Drive type: hydraulic floor jack
• Construction: welded steel frame
• Minimum saddle height: low-profile design for reduced approach height
• Maximum lifting height: suitable for typical vehicle service tasks (refer to user manual for exact measurement)
• Base: wide, reinforced for stability on workshop floors
• Operation: manual hydraulic pump with release valve for controlled descent

How to use

Position the jack on a firm, level surface and place it under the manufacturer-recommended lifting point of the vehicle. Pump the hydraulic handle to raise the saddle until it contacts the lifting point, then continue pumping until the required height is reached. Support the vehicle with appropriate axle stands before performing any work beneath the vehicle. To lower, open the release valve slowly to allow controlled descent. Follow the safety and operating procedures in the supplied manual for correct use and periodic maintenance.

Usage recommendations

Use only on solid, level surfaces and always employ certified axle stands for under-vehicle work. Do not exceed the rated 5-ton capacity. Regularly inspect hydraulic seals, frame welds and the release valve for wear or damage, and perform maintenance according to the manufacturer’s instructions to ensure safe operation.