Thermal pad Gelid TP-VP04-A — 90×50×2 mm, density 3.2 g/cm³, grey

Gelid TP-VP04-A is a grey thermal pad measuring 90 × 50 × 2 mm with a density of 3.2 g/cm³, supplied as a single piece. It is designed as an electrically insulating, conformable thermal interface material to improve heat transfer between electronic components and heatsinks. The pad accommodates height differences and uneven surfaces on PC components, embedded systems and other densely packed electronics, providing a stable thermal pathway without curing or electrical conductivity.

Advantages

The thermal pad is non-electrically conductive, non-corrosive and non-toxic, offering a reliable and safe interface for sensitive circuitry. Its multilayer matrix and formulated material enable compliance with surface irregularities to fill gaps between components and heatsinks, improving thermal contact. The pad supports an extended operating temperature range from -60°C to 220°C and is easy to apply and trim to fit specific layouts.

Suitable for

• Thermal management on GPUs, motherboards and add-on cards
• Power MOSFETs, chipsets and analog ICs with uneven surfaces
• Microcontroller units and other SMD components in embedded systems
• Large PCB surfaces where a 90×50 mm pad is required

Key specifications

• Dimensions: 90 × 50 × 2 mm
• Density: 3.2 g/cm³
• Colour: Grey
• Electrical property: electrically insulating (non-conductive)
• Temperature range: -60°C to 220°C
• Material behaviour: conformable, non-curing

How to use

Clean contact surfaces to remove dust, grease and old thermal interface residue. Measure and cut the Gelid TP-VP04-A pad to the required shape if necessary, using a sharp blade or scissors. Place the pad between the component and the heatsink ensuring full coverage of the contact area, and then assemble the heatsink with even pressure to allow the pad to conform to surface irregularities. No curing time is required; the pad provides immediate thermal interface performance.

Usage recommendations

For best results, verify component heights and available clearance before installation. Ensure the pad thickness (2 mm) is appropriate for the gap; if a different thickness is needed consult available variants. Avoid stretching the pad during placement and replace the pad if it becomes contaminated or physically damaged.