GF 90° Press Elbow 16 x 1/2" Female Thread, Model 5S0021H041620T

GF 90° press elbow with a 16 mm press connection to a 1/2" female (G) threaded outlet is engineered to provide a compact, right‑angle transition between press‑fit piping systems and standard female‑threaded components. Intended for use in water distribution, heating manifolds and sanitary fixture connections, this elbow combines a press joint on one side and a threaded outlet on the other to facilitate reliable, low‑profile installation where a turn to a female threaded connection is required.

Advantages

The press elbow offers a secure, vibration‑resistant press connection that reduces the need for soldering or welding. The integrated 1/2" female threaded outlet enables direct attachment of standard fittings and fixtures without additional adapters. Its compact 90° form factor saves space in tight installations and helps maintain a tidy piping layout. Material selection and manufacturing tolerance provide compatibility with common metal and plastic press systems used in plumbing and heating.

Suitable for

• Domestic and commercial water distribution systems
• Heating manifolds and radiator connections
• Sanitary fixtures and mixer tap installations
• Transitions between press‑fit pipelines and threaded valves or fittings

Key specifications

• Connection A: 16 mm press connection for press‑fit piping
• Connection B: 1/2" female (G) threaded outlet
• Angle: 90° elbow
• Application: potable water, heating and sanitary installations
• Design: compact, low‑profile right‑angle fitting

How to use

Prepare the press‑fit pipe by cutting square and deburring the end. Insert the prepared pipe fully into the 16 mm press socket until it reaches the internal stop. Use a compatible press tool and jaw sized for 16 mm connections to perform the press operation according to the press tool manufacturer’s instructions. For the 1/2" female threaded outlet, apply an appropriate thread sealant (such as PTFE tape or approved sealant) to the male thread of the mating component, then hand‑tighten and finish to the required torque with suitable tools. Verify the assembled joint for alignment and, after system pressure testing, inspect for any leaks.

Usage recommendations

Use only with compatible 16 mm press‑fit piping systems and approved press tools and jaws. Ensure the threaded counterpart matches the 1/2" female (G) standard and apply an appropriate thread sealant. Perform pressure testing after installation following local codes and manufacturer guidelines to confirm leak‑tightness.