Protective film GrizzGlass BodyShield for Tesla Model S (2023–2025) — set for door handles (4 in 1)

GrizzGlass BodyShield protective film is designed for Tesla Model S (2023–2025) specifically to cover and protect the paint around the original door handles. This 4-in-1 set contains pre-cut, adhesive films shaped to fit the recesses and surrounding areas of the handles. The thin, transparent material preserves the vehicle’s finish while reducing the risk of scratches, scuffs and visible wear caused by fingernails, rings and frequent use. The set is intended for exterior surface protection and household-style DIY installation without modifying the original parts.

Advantages

The film offers a nearly invisible barrier that maintains the factory paint appearance while providing resistance against minor abrasions and marks. Pre-cut pieces ensure consistent coverage and reduce trimming or measuring during installation. The adhesive backing is formulated for exterior use, balancing strong adhesion with the ability to remove the film later without leaving substantial residue when removed correctly. The product is tailored to the specific geometry of Tesla Model S door handle areas for a precise fit.

Suitable for

• Protection of paint around Tesla Model S (2023–2025) original door handles
• Preventing scratches from fingernails, rings and keys
• Preserving exterior finish on frequently touched areas
• DIY surface protection projects on vehicle door handles

Key specifications

• Set composition: 4 pre-cut transparent adhesive films for door handle areas
• Material type: thin protective polymer film designed for automotive exterior use
• Finish: transparent / clear to preserve original paint color and gloss
• Compatibility: shaped for Tesla Model S production years 2023–2025 door handle geometry
• Installation method: adhesive-backed, dry or wet installable depending on installer preference

How to use

Before applying the film, clean the door handle area thoroughly with isopropyl alcohol or an approved auto-surface cleaner to remove grease, wax and dirt. Dry the surface completely. Align the pre-cut piece with the handle recess, peel back a portion of the protective liner and position the film. Use a soft squeegee or microfiber cloth to press the film into place, working from the center outward to expel air and excess water if a wet method was used. Trim any excess only if necessary and allow the adhesive to set according to ambient temperature; avoid washing the car or exposing the area to heavy moisture for at least 24 hours after installation.

Usage recommendations

For best results, perform installation in a dust-free environment at moderate temperature (15–25°C). If unsure about alignment or fit, test-fit the film before removing the entire backing. When removing the film, heat the area gently with a hair dryer to soften the adhesive and peel slowly at a low angle to minimize residue and protect the paint.