Headlight protective film GrizzGlass BodyShield for Tesla Model 3 (2017–2020) 2-in-1 set

GrizzGlass BodyShield for Tesla Model 3 (2017–2020) is a transparent protective film designed specifically to cover and protect the front headlamps. Supplied as a 2-in-1 set, each piece is pre-cut to match the lamp contours of the Model 3 for a precise fit. The film protects against light scratches, stone chips and gradual environmental wear while preserving optical clarity and beam performance. It can be applied as a do-it-yourself job or installed by a professional to extend the service life of headlight lenses.

Advantages

The film is engineered to remain optically clear, minimising any impact on light output and keeping original headlight appearance. Its tailored shape for Tesla Model 3 ensures edge-to-edge coverage with minimal trimming and accurate alignment. The material resists minor abrasions and stone impacts, reducing the likelihood of chips and surface damage. As a transparent protective layer, it helps maintain resale value and reduces the need for costly headlight refurbishment or replacement.

Suitable for

• Owners of Tesla Model 3 (2017–2020) seeking protection for factory headlamps
• DIY car care enthusiasts who prefer straightforward, pre-cut film installations
• Workshops and detailers offering headlight protection services
• Drivers in regions with frequent road debris, gravel or harsh weather

Key specifications

• Compatibility: Tesla Model 3, model years 2017–2020
• Set contents: two pre-cut transparent headlight film pieces (2-in-1 set)
• Material properties: optically clear protective film resistant to minor scratches and stone chips
• Finish: transparent, non-tinted to preserve original lamp color and beam pattern
• Application: pressure-sensitive adhesive suitable for exterior automotive use

How to use

Clean the headlight surface thoroughly to remove dirt, grease and wax residues before application. Position the pre-cut film on the lamp to check fit, then apply using a squeegee or soft applicator to remove air bubbles and excess moisture. Trim any minor excess where necessary and allow the adhesive to cure according to ambient temperature and humidity — follow the included instructions for best results. For complex edges or if unsure about fit, professional installation is recommended.

Usage recommendations

For long-lasting protection, avoid high-pressure car washes for the first 48 hours after installation and inspect edges periodically. Clean with mild, non-abrasive detergents and soft cloths to preserve optical clarity.