Protective film GrizzGlass BodyShield for Audi A4 Avant (2019–2024) set 4-in-1

GrizzGlass BodyShield for Audi A4 Avant (2019–2024) is a clear, adhesive protective film kit designed to cover the wheel arch areas of the vehicle. Supplied as a 4-in-1 set, the film conforms to curved surfaces and provides a transparent shield that preserves the original paint finish while reducing damage from road debris, stone chips and light abrasion. The product is intended for exterior paint protection in wheel well zones and is formulated to remain unobtrusive once installed.

Advantages

The film combines impact resistance with optical clarity so that the vehicle’s factory paint and texture remain visible. Its adhesive backing is engineered for secure adhesion to automotive paint without altering surface appearance when properly applied. The kit format includes pre-cut pieces for the wheel arches, which simplifies alignment and reduces trimming. The material resists yellowing and is designed to withstand common road contaminants, helping to maintain the car’s exterior condition over time.

Suitable for

• Protecting wheel arches on Audi A4 Avant (2019–2024) from stone chips
• Reducing fine scratches and abrasion on exterior painted surfaces
• Preserving resale value by limiting visible paint damage
• Owners who prefer an invisible protection solution for wheel wells

Key specifications

• Kit composition: 4 pre-cut film pieces tailored for wheel arch coverage
• Finish: transparent, high optical clarity to preserve original paint appearance
• Material properties: impact and abrasion-resistant protective polymer
• Adhesive: pressure-sensitive automotive-grade adhesive for stable bond
• Durability: UV-stable formulation to resist yellowing and environmental exposure

How to use

Clean the application areas thoroughly to remove dirt, wax, and grease before applying the film. Use a mild detergent and isopropyl alcohol if necessary, and ensure the surface is fully dry. Position the pre-cut pieces over the wheel arch contours to check fit, then gradually remove the backing and apply the film from one edge, smoothing out air bubbles with a soft squeegee or microfiber cloth. For edges and tight curves, apply heat gently with a heat gun or hair dryer to aid conformity, taking care to keep the temperature at safe levels for automotive paint and film. Trim any excess only if required and allow the adhesive to set according to ambient conditions.

Usage recommendations

For best results, install in a dust-free environment at moderate temperature (ideally 15–25°C). If unsure about applying the film yourself, professional installation at an auto workshop is recommended to ensure proper adhesion and visual finish. Periodic cleaning with non-abrasive automotive cleaners will help maintain transparency and extend service life.