Protective Door Sill Film GrizzGlass BodyShield for Forthing U-tour (2024–2025) 4-piece set

GrizzGlass BodyShield protective door sill film for the Forthing U-tour (2024–2025) is a 4-piece set of pre-cut, self-adhesive panels designed to protect entry sills from scratches, scuffs and everyday wear while preserving the vehicle's original paint. The transparent film follows the shape of the sill area to provide discreet protection in high-contact zones without altering the car's appearance.

Advantages

The film is precisely cut to match the door sill contours of the Forthing U-tour, ensuring a clean fit and consistent coverage. Made from durable, transparent material, the panels resist abrasion and help prevent paint damage caused by shoes, luggage and frequent ingress and egress. The self-adhesive backing allows for secure mounting and long-term adhesion while remaining removable if necessary, with minimal risk of residue when removed correctly.

Suitable for

• Protecting front and rear door sills from scratches and scuffs
• Preserving original paint during daily use and when transporting cargo
• Use in private vehicles, leased cars or fleet vehicles to reduce wear
• Owners seeking a discreet, nearly invisible protection solution

Key specifications

• Quantity: 4 pre-cut panels sized for Forthing U-tour door sills (2024–2025)
• Material: transparent protective film with abrasion-resistant surface
• Attachment: permanent-style self-adhesive backing for strong adhesion
• Finish: clear, low-gloss to maintain original paint appearance
• Protection: guards against scratches, scuffs and light impacts at entry points

How to use

Clean the door sill surface thoroughly with a mild solvent or isopropyl alcohol and allow it to dry completely. Position each pre-cut film panel to check alignment before removing the adhesive liner. Carefully peel the liner and apply the panel starting from one edge, smoothing across the surface to avoid air bubbles. Use a soft squeegee or microfiber cloth to press the film into place and ensure full contact along edges and contours. If necessary, trim excess material with a sharp blade and apply light heat with a hair dryer to conform the film to complex curves.

Usage recommendations

For best results, apply the film at temperatures between 15–25°C on a dust-free surface. Avoid high-pressure washes or aggressive chemical cleaners for 48 hours after installation to allow the adhesive to set fully. Periodically inspect the edges and clean the protected area with gentle car shampoo to maintain appearance and longevity.