Protective bumper film GrizzGlass BodyShield for Tesla Model 3 (2017–2020) 2-in-1

GrizzGlass BodyShield for Tesla Model 3 (2017–2020) is a precision-cut protective bumper film supplied as a 2-in-1 set. Designed for exterior application on the front bumper, the film shields painted surfaces from scratches, stone chips and minor abrasions while maintaining the original finish. The kit matches the contours of the specified Model 3 front bumper to provide long-term preventive protection without altering appearance.

Advantages

The film uses an optically clear, durable polymer that absorbs impact from small debris and resists yellowing and UV degradation. Its slim, conformable profile ensures paint preservation and retains original gloss and texture. The 2-in-1 format covers key impact zones and allows for targeted replacement if one piece is damaged. The material is reversible and removable without leaving adhesive residue when removed by a trained professional.

Suitable for

• Preventing stone chips and paint damage on the front bumper of Tesla Model 3 (2017–2020)
• Protecting against light scratches and minor abrasions in urban and highway driving
• Maintaining original paint finish and resale value
• Fleet vehicles and lease returns where paint condition is important

Key specifications

• Fit: Precision-cut for Tesla Model 3 front bumper, model years 2017–2020
• Set: 2-in-1 pieces covering primary impact areas
• Material: Optically clear protective polymer film with UV stability
• Thickness: Thin, conformable profile suitable for curved surfaces
• Finish: Maintains gloss and texture of original paint
• Application area: Exterior front bumper

How to use

Clean the bumper thoroughly to remove dirt, grease and road film; use a mild detergent and isopropyl alcohol for final surface preparation. Position the film pieces on the bumper and align to existing contours, then apply using a squeegee from the center outward to remove trapped water and air. Apply heat with a low-temperature heat gun or infrared tool to conform the film into tight curves and edges. Trim any excess if necessary and allow the adhesive to cure as specified by the installer. For best results, have the film installed by a trained installer familiar with exterior automotive protective films.

Usage recommendations

Store unopened film flat in a cool, dry place away from direct sunlight. Avoid high-pressure washing at close range on edges for the first 48–72 hours after installation to allow full adhesive set. Inspect film periodically and replace individual pieces from the 2-in-1 set if deep cuts or severe damage occur.