Protective bumper film GrizzGlass BodyShield for Nissan Juke Facelift 2024–2025, 2-in-1

GrizzGlass BodyShield for Nissan Juke Facelift 2024–2025 is a transparent protective bumper film supplied as a 2-in-1 kit. Designed to fit the bumper surfaces of the specified Nissan Juke facelift models, the film creates a clear barrier that preserves the original paint finish while reducing the risk of damage from road debris, stone chips and light abrasions. The kit format covers primary impact areas and allows for either professional installation or careful DIY fitting to maintain the vehicle’s exterior appearance and lower potential repair costs.

Advantages

The film is optically clear and engineered to remain nearly invisible once applied, maintaining factory gloss and colour. Its durable surface resists common causes of bumper damage such as small stones and scraping, and the material offers flexibility to conform to curved bumper profiles. Supplied as a 2-in-1 kit, BodyShield provides coverage for multiple zones on the bumper and simplifies replacement of individual pieces if needed, helping preserve resale value by preventing paint damage.

Suitable for

• Owners of Nissan Juke Facelift 2024–2025 seeking paint protection for front and rear bumper areas
• Professional installers and body shops performing precise pre-cut film fitting
• Car owners preferring DIY application with careful preparation and patience
• Vehicles frequently driven on gravel roads or in urban environments with risk of stone chips

Key specifications

• Material: high-clarity protective film with scratch- and chip-resistant surface
• Finish: transparent glossy layer designed to match original paint gloss
• Kit format: 2-in-1 pre-cut pieces shaped for bumper coverage
• Flexibility: conforms to curved bumper contours and recessed details
• Thickness: engineered for impact dispersal while maintaining optical clarity

How to use

Clean the bumper thoroughly to remove dirt, wax and road film before application. Position the pre-cut pieces on the bumper to verify fit, then apply the film using a squeegee and a mild soapy spray solution to allow positioning and to remove air bubbles. Work from the centre outward and use slow, firm strokes to ensure adhesion along curves and recesses. Trim any excess if necessary and allow the film to set according to ambient temperature and humidity before exposing the vehicle to heavy wash or high-pressure water.

Usage recommendations

For best results, have the surface professionally prepared or use an approved surface cleaner, and allow 24–48 hours after installation for full adhesive curing. Avoid automatic high-pressure washes immediately after fitting and inspect edges periodically to ensure continued adhesion and protection.