Protective pillar film GrizzGlass BodyShield for Cupra Formentor (2020–2024), set 8 pieces

GrizzGlass BodyShield protective pillar film is a pre-cut set of eight transparent pieces designed specifically for the Cupra Formentor (model years 2020–2024). The film covers door pillars and adjacent painted surfaces to reduce the risk of scratches, stone chips and wear from daily use while maintaining the factory appearance and gloss of the vehicle.

Advantages

The film is cut to fit the Cupra Formentor’s pillar contours, enabling precise coverage without trimming. Its transparent finish preserves original paint color and gloss while providing a thin, durable barrier against mechanical damage and minor impacts. The material is resistant to yellowing and environmental factors typical in urban and highway driving, and its adhesive allows secure placement with low risk of edge lifting when installed correctly.

Suitable for

• Protecting door pillars from scratches caused by opening doors, keys and items carried by passengers
• Preventing paint chips and abrasion in urban and suburban driving conditions
• Maintaining the appearance of used vehicles to reduce visible wear
• Owners who prefer a non-visible protective solution that preserves original finish

Key specifications

• Compatibility: Cupra Formentor, model years 2020–2024
• Quantity: set of 8 pre-cut pieces for pillar coverage
• Color/finish: transparent, glossy finish to match painted surfaces
• Material properties: thin, durable protective film with adhesive backing
• Purpose: protection against scratches, chips and surface wear

How to use

Before installation, clean the pillar surfaces thoroughly with a non-abrasive cleaner and ensure they are dry and free of wax, grease and dust. Position each pre-cut film piece on the corresponding pillar to verify fit. Peel back part of the protective liner and apply the adhesive side, smoothing the film from the center outward to remove air bubbles and ensure full contact. Use a soft squeegee or microfiber cloth to press the film along the edges. If needed, small trapped bubbles can be worked out toward the edge; avoid using sharp tools that could cut the film.

Usage recommendations

Install in a controlled environment at moderate temperature (ideally 15–25°C) for best adhesion. Allow the adhesive to cure for 24–48 hours before subjecting the vehicle to high-pressure washing or extreme temperature changes. For long-term maintenance, clean treated surfaces with mild automotive soap and avoid abrasive polishes or aggressive chemicals.