Protective film GrizzGlass BodyShield for door handles, compatible with Seat Leon (2024–2025) — set 4 pieces

GrizzGlass BodyShield protective film set for door-handle areas is made to protect the paint around exterior door handles of Seat Leon models from 2024 to 2025. This set includes four pre-cut transparent patches shaped to match typical handle recesses, providing a discreet barrier that reduces scratches, scuffs and paint wear caused by fingernails, rings and frequent use. The low-profile film is designed to conform to curved surfaces while remaining nearly invisible once applied.

Advantages

The films are thin and transparent, ensuring minimal visual impact while delivering focused protection exactly where it is needed. Pre-cut shapes simplify installation and reduce trimming; the adhesive backing is formulated to adhere securely without damaging factory paint when removed correctly. The set of four covers both front and rear doors, helping maintain the vehicle’s appearance and lowering the likelihood of costly touch-ups or repainting.

Suitable for

• Seat Leon (2024–2025) with standard exterior door-handle recesses
• Owners aiming to prevent scratches and paint wear around door handles
• Vehicles frequently used in urban environments where keys and rings contact handles
• Detailing or maintenance tasks focused on long-term paint preservation

Key specifications

• Quantity: 4 pre-cut protective films
• Material: thin transparent protective film designed for automotive paint protection
• Coverage: shaped to fit door-handle recesses for compact cars similar to Seat Leon
• Finish: low-profile, near-invisible appearance after application
• Adhesive: removable automotive-grade adhesive formulated for safe removal

How to use

Clean the application area thoroughly with a non-greasy cleaner and allow it to dry. Peel the film from its backing and position the pre-cut patch over the door-handle recess, aligning edges carefully. Apply pressure from the center outward to remove air pockets and ensure full contact with the paint. If necessary, trim excess material only where indicated by fit. Allow the adhesive to set according to ambient temperature recommendations before regular use.

Usage recommendations

For best results, apply films at room temperature on a clean, dry surface and avoid washing the vehicle for 24 hours after installation. To remove, gently lift an edge and peel slowly at a low angle; if any residue remains, remove it with a mild adhesive remover approved for automotive paint.