Protective film GrizzGlass BodyShield for Opel Grandland 2021–2024, set 10 pieces

GrizzGlass BodyShield protective film for Opel Grandland 2021–2024 is a pre-cut set of ten clear film pieces designed to protect exterior door pillars and vulnerable trim areas. The transparent, low-profile material preserves the original paint finish while providing a protective barrier against scratches, stone chips and abrasion from regular use. Each piece is shaped to match common pillar and trim contours on Opel Grandland models from the specified years for straightforward alignment during installation.

Advantages

The film offers discreet, near-invisible protection without changing the vehicle’s appearance and is resistant to everyday mechanical damage such as key scratches, minor impacts and wear from loading and unloading. Its adhesive backing is formulated for automotive surfaces to ensure secure adhesion and long-term durability while allowing removal without significant residue when removed correctly. The set approach gives full coverage for both sides of the vehicle’s pillars and multiple trim sections.

Suitable for

• Protecting door pillars on Opel Grandland 2021–2024
• Shielding painted trim and narrow exterior surfaces from scratches and chips
• Aftermarket protective upgrade for leased or new vehicles
• Preventive protection in high-contact areas such as door openings and loading zones

Key specifications

• Contents: set of 10 pre-cut transparent film pieces
• Material: durable, abrasion-resistant clear protective film
• Surface: designed for exterior painted surfaces and trim
• Adhesive: automotive-grade pressure-sensitive adhesive for stable bonding
• Finish: optically clear to preserve original paint appearance

How to use

Clean the application area thoroughly with a grease-free cleaner and dry completely before applying film. Test-fit each pre-cut piece to check alignment, then remove the release liner and apply the film gradually, smoothing from the center outward to expel air and avoid bubbles. Use a soft squeegee or microfiber cloth to press the edges firmly and ensure full contact with the surface. Allow the adhesive to set according to ambient temperature instructions before exposing the treated areas to heavy washing or mechanical stress.

Usage recommendations

Apply at moderate temperatures (ideally 15–25°C) on a clean, dry surface. Avoid high-pressure washers directly along film edges during the initial 48–72 hours after installation. For removal, warm the film slightly with a heat gun or warm air to reduce adhesive strength and peel slowly at a low angle to minimize residue; any remaining adhesive can be cleaned with a dedicated adhesive remover safe for painted surfaces.