Protective door handle film GrizzGlass BodyShield for Fiat 500 (2016–2025) 2‑in‑1

GrizzGlass BodyShield protective door handle film is a pre-cut, self-adhesive film tailored for the Fiat 500 model years 2016–2025. Supplied as a 2-in-1 set, each piece covers the paint around the door handle area to prevent scratches, scuffs and damage caused by rings, keys and repeated use. The film is designed for a near-invisible finish that preserves the exterior appearance while providing targeted protection where wear commonly occurs.

Advantages

The film is cut to fit the Fiat 500 2016–2025 door handle contours, which simplifies alignment and reduces trimming during installation. Its self-adhesive backing ensures firm adhesion to the vehicle surface and long-lasting protection without altering the look of the car. The material resists common mechanical wear and helps maintain original paintwork by limiting micro-scratches and abrasion in the handle area.

Suitable for

• Protecting paint around exterior door handles on Fiat 500 (2016–2025)
• Preventing scratches from keys, rings and frequent hand contact
• Maintaining resale value by preserving visible exterior surfaces
• Discrete protection where preservation of original finish is desired

Key specifications

• Shape: pre-cut to match door handle contour of Fiat 500 (2016–2025)
• Set contents: 2 pieces (2-in-1)
• Adhesion: permanent self-adhesive backing for vehicle paint
• Finish: near-invisible, low-gloss protective film
• Protection type: guards against scratches, scuffs and abrasion

How to use

Clean the door handle area thoroughly to remove dirt, grease and wax, then dry completely. Carefully position the pre-cut film over the handle area to check fit before removing the backing. Peel off the adhesive liner progressively while aligning the film; press from the center outward to eliminate air pockets and ensure full contact. Smooth the edges with a soft cloth or squeegee, taking care not to stretch the film. Allow adhesive to cure undisturbed for the time recommended by the manufacturer before washing or exposing to heavy moisture.

Usage recommendations

For best results, apply the film at ambient temperatures between 15–25°C on a clean, dry surface. If necessary, use isopropyl alcohol (IPA) for cleaning and avoid silicone-based polishes before installation. Inspect the film periodically and replace if severe damage occurs; avoid using harsh abrasives on the protected area.