Protective film GrizzGlass BodyShield for rear wheel arches — Seat Ibiza (2021–2025) 4-piece set

GrizzGlass BodyShield protective film is tailored for the rear wheel arches of Seat Ibiza models produced between 2021 and 2025. This 4-piece set includes pre-cut, form-fitting panels that follow the factory contours of the wheel arch area to protect painted surfaces from stone chips, road debris and abrasion while maintaining the original look and paint adhesion. The transparent, thin film is designed to remain discreet after installation and to provide a durable, long-term barrier against common sources of localized paint damage.

Advantages

The panels are pre-cut to match the rear wheel arch geometry, which reduces trimming and fitting time and ensures consistent coverage. The film preserves the factory paint finish and adhesion because it is thin, optically clear and conformable to curved surfaces. It resists tearing and typical road contaminants and can be installed as a DIY project or fitted professionally. Because the film is nearly invisible, it protects without altering the vehicle’s appearance or surface texture.

Suitable for

• Protecting rear wheel arches from stone chips and gravel impacts
• Preventing paint abrasion and scuffs near wheel wells
• Maintaining original paint finish on daily-driven vehicles
• Do-it-yourself installation or professional fitting in body shops

Key specifications

• Set composition: 4 pre-cut panels for both rear wheel arches
• Material type: clear protective polymer film with adhesive backing
• Finish: optically clear, low-gloss to visually discreet appearance
• Conformability: designed to follow curved wheel-arch surfaces
• Durability: resistant to stone chips, abrasion and common road contaminants
• Compatibility: shaped specifically for Seat Ibiza models from 2021 to 2025

How to use

Before applying, thoroughly wash and dry the wheel-arch area to remove dirt, grease and loose particles. Test-fit the pre-cut panels to confirm correct position and orientation. Remove the backing from the adhesive side and apply the film starting from one edge, smoothing progressively with a soft squeegee or cloth to avoid air bubbles and ensure full contact with the painted surface. Warm the film slightly with a heat gun on low setting if necessary to improve conformability around tight curves, and allow the adhesive to set according to ambient temperature recommendations. Trim any excess if required by the fit but avoid cutting into surrounding painted surfaces.

Usage recommendations

For best results, apply film at moderate temperatures (15–25°C) on a clean, dry surface. If unsure about placement or complex contours, consider professional installation. Regularly inspect the edges for lift or trapped debris and clean gently using mild automotive soap and water; avoid aggressive chemicals or high-pressure washers directed at the film edges.