Protective Film GrizzGlass BodyShield for Lexus LBX (2023–2025) — set for door handles (4-in-1)

GrizzGlass BodyShield protective film for Lexus LBX (2023–2025) is a set of four pre-cut transparent patches designed to protect door handle recesses from scratches, paint chipping and wear. The thin yet durable film follows the contours of the handle area and remains nearly invisible after installation, preserving the original look and tactile feel of the vehicle while providing targeted protection where daily contact and keys can cause damage.

Advantages

The kit contains precise, pre-cut pieces shaped for Lexus LBX door handle areas to ensure a close fit and minimal trimming. Made from a clear, durable polymer, the film resists abrasion and helps prevent paint damage without altering the surface finish. Its adhesive backing supports bubble-free application and stable adhesion over time, while the thin profile keeps the protective layer discreet and unobtrusive.

Suitable for

• Protecting door handle recesses on Lexus LBX models from 2023 to 2025
• Preventing scratches caused by rings, keys and daily use
• Maintaining original paint finish and resale value
• DIY installation or professional fitting during detailing or wrap services

Key specifications

• Contents: 4 pre-cut transparent protective film pieces for door handles
• Material: thin, abrasion-resistant polymer film
• Finish: clear / high transparency to preserve original appearance
• Adhesive: pressure-sensitive adhesive for secure, bubble-minimised application
• Coverage: designed for inner handle recesses and surrounding contact areas

How to use

Clean the door handle recess thoroughly with a lint-free cloth and an alcohol-based cleaner to remove dirt, oils and wax residues. Position the pre-cut film piece over the handle recess to check alignment, then peel the backing gradually while smoothing the film into place from the center outward to avoid trapped air. If needed, use a soft squeegee or microfiber cloth to press the film down and remove any remaining bubbles. Trim any excess material only if the piece requires minor adjustment to match the recess edge.

Usage recommendations

For best adhesion and durability, apply the film at temperatures between 15–25 °C on a dry surface. Avoid high-pressure car washes for 24–48 hours after installation and allow the adhesive to fully set. For long-term protection, inspect edges periodically and replace pieces if significant lifting or damage occurs.