Protective Door Sill Film GrizzGlass BodyShield for Lexus RX 350h (2022–2025) 4-piece set

GrizzGlass BodyShield protective door sill film for Lexus RX 350h (2022–2025) is a pre-cut, transparent sill protection set designed to guard painted door sills against scratches, scuffs and abrasion caused by passenger entry and exit. The four-piece kit is shaped to follow the factory sill contours for a near-invisible fit that preserves the vehicle's appearance while reducing everyday wear on high-contact areas.

Advantages

The film is transparent and thin, providing discreet protection without altering the sill's appearance or texture. Pre-cut pieces match the original sill geometry to simplify alignment and reduce trimming. The adhesive is formulated for automotive exterior surfaces to provide strong initial tack and durable long-term adhesion while allowing clean removal when necessary. The material resists minor abrasions and helps prevent paint damage from shoes, luggage and frequent use.

Suitable for

• Owners of Lexus RX 350h model years 2022–2025 seeking surface protection for door sills
• Daily-driven vehicles with frequent passenger ingress and egress
• Cars with new or freshly refinished sills where paint preservation is desired
• Drivers who prefer a near-invisible, non-invasive protection solution

Key specifications

• Kit composition: 4 pre-cut sill film pieces covering front and rear door sills
• Color/finish: transparent, glossy surface
• Material: automotive-grade protective film with durable surface layer
• Adhesive: pressure-sensitive automotive adhesive designed for painted metal and plastics
• Fitment: shaped to follow factory sill contours for Lexus RX 350h (2022–2025)

How to use

Clean the door sill area thoroughly with a mild solvent or isopropyl alcohol and a lint-free cloth to remove dirt, grease and wax. Align the pre-cut film with the sill contour, peel back a portion of the liner and apply the leading edge while smoothing to avoid trapped air. Gradually remove the liner and press the film into place using firm, even pressure; a soft squeegee can help eliminate bubbles and ensure full contact. Allow the adhesive to settle for several hours before exposing the area to heavy use or washing.

Usage recommendations

For best results, perform installation in a dust-free environment at moderate temperature (around 15–25°C). If trimming is required for exact fit, use a sharp utility knife and a straight edge. When removing the film after extended use, heat the area slightly with a hair dryer or heat gun on low to soften the adhesive for cleaner removal.