Protective Rear Bumper/Boot Sill Film GrizzGlass BodyShield for Volkswagen Passat B6 Sedan (2005–2010)

GrizzGlass BodyShield protective film is made to fit the rear bumper and boot sill area of the Volkswagen Passat B6 Sedan (2005–2010). This cut-to-fit adhesive layer protects the vehicle's paint from scratches, scuffs and abrasion that commonly occur during loading and unloading. The film follows factory contours and preserves the original finish while remaining visually discreet.

Advantages

The film delivers a thin, impact-absorbing barrier that reduces surface damage without altering the look of the bumper or sill. It is pre-cut for the specified model area to ensure precise coverage and easier alignment during installation. The adhesive is formulated to adhere securely while allowing residue-free removal, and the transparent material maintains colour fidelity and gloss of the original paint.

Suitable for

• Protecting the rear bumper and boot sill of Volkswagen Passat B6 Sedan (2005–2010)
• Preventing scratches and scuffs from luggage, sports equipment and shopping
• Maintaining resale value by preserving original paintwork
• Discrete protection where visual impact should be minimal

Key specifications

• Fit type: Pre-cut for Volkswagen Passat B6 Sedan rear bumper/boot sill (2005–2010)
• Material: Transparent protective adhesive film designed for exterior automotive use
• Protection properties: Scratch, scuff and abrasion resistance during loading/unloading
• Finish: Clear, high-transparency surface that preserves paint colour and gloss
• Removal: Designed for residue-free removal when taken off correctly

How to use

Clean the installation area thoroughly to remove dirt, grease and wax. Dry the surface completely. Position the pre-cut film on the rear bumper or boot sill and align it with factory contours. Gradually remove the backing while smoothing the film onto the surface to avoid air bubbles and creases; use a soft squeegee or cloth for even adhesion. If necessary, trim any excess along the edges with a sharp blade. Allow the adhesive to settle according to ambient temperature recommendations before exposing the area to heavy use.

Usage recommendations

Apply the film at room temperature on a clean, dry surface and avoid washing the area with high-pressure water jets for 24–48 hours after installation to ensure optimal adhesion. For best results, store the product flat and avoid prolonged exposure to direct sunlight prior to fitting.