Protective film GrizzGlass BodyShield for door handle areas for Audi A3 8P Hatchback 5D (2003–2008) set 4 pieces

GrizzGlass BodyShield protective film set for Audi A3 8P Hatchback 5D (2003–2008) contains four pre-cut transparent adhesive patches designed to protect the painted surface around exterior door handle areas. Each patch is shaped to fit the recesses behind the handles, preserving the vehicle's original finish while remaining discreet and nearly invisible once applied. The material resists minor scratches, chips and abrasion caused by rings, keys and general use.

Advantages

The self-adhesive films are pre-cut to match the door handle contours, which simplifies installation and ensures consistent coverage. Transparent construction maintains the original paint color and gloss without altering the car's appearance. The thin, durable polymer layer provides a protective barrier against everyday wear while remaining weather-resistant and compatible with routine washing. Removal leaves minimal residue when performed according to instructions.

Suitable for

• Protection of paint around exterior door handles on Audi A3 8P Hatchback 5D (2003–2008)
• Preventing scratches and chips from rings, keys and fingernails
• Daily-use and city parking protection where frequent contact occurs

Key specifications

• Quantity: set of 4 pre-cut adhesive films
• Color: transparent
• Application area: exterior door handle recesses
• Material type: thin protective polymer film
• Surface finish: glossy, low-visibility

How to use

Clean the application area thoroughly with a mild detergent and ensure it is fully dry and free of wax, polish or contaminants. Peel the protective backing from the pre-cut film, align the patch with the door handle recess and apply from one edge, smoothing outward to avoid trapped air. Apply light pressure across the film to ensure adhesion; a microfiber cloth or soft squeegee can be used to remove bubbles. Allow the adhesive to set for several hours before exposing the area to heavy washing or extreme conditions.

Usage recommendations

For best results, install films at ambient temperatures between 15–25°C and on a dust-free surface. If removal is required, gently heat the film edge with a hairdryer and peel slowly at a low angle to reduce residue. Clean residual adhesive with isopropyl alcohol if necessary. Avoid polishing directly over the film with abrasive compounds.