Protective Headlight Film GrizzGlass BodyShield for BMW 3 Series E90 Sedan LCI (2008–2012) [2-in-1]

GrizzGlass BodyShield protective headlight film is tailored for the BMW 3 Series E90 Sedan LCI (2008–2012). Supplied as a 2-in-1 kit, the transparent, high-clarity film covers and protects headlamp lenses without affecting beam performance. The material is engineered to resist stone chips, minor scratches, UV-induced yellowing and everyday wear, helping to preserve optical clarity and extend the service life of factory headlamps. The kit is suitable for both DIY fitting and professional installation, and it is cut to match the contours of the E90 LCI sedan headlights for accurate coverage.

Advantages

The film provides durable surface protection while maintaining original light output and lens appearance. Its UV-resistant composition reduces discoloration and fading over time. The thin, conformable film adheres closely to curved lens profiles to minimise visible edges and reduce the risk of peeling. Supplied as a two-piece set, the kit simplifies coverage of both headlamps and reduces the need for multiple separate components.

Suitable for

• Protecting headlamp lenses on BMW 3 Series E90 Sedan LCI (2008–2012)
• Preventing stone chip damage and minor scratches
• Maintaining lens clarity and light output over time
• DIY fitting or professional bodyshop installation

Key specifications

• Compatibility: BMW 3 Series E90 Sedan LCI (2008–2012)
• Kit type: 2-in-1, two-piece set for both headlamps
• Material: transparent protective film with UV-resistant coating
• Protection: impact chips, minor abrasions, scratches and UV fading
• Optical performance: preserves original light transmission and beam pattern
• Form factor: pre-cut to match headlamp contours for accurate fit

How to use

Prepare the headlamp surface by cleaning thoroughly with a lint-free cloth and an appropriate surface cleaner to remove dirt, wax and residues. Position the pre-cut film on the lens to check alignment, then apply using a wet installation method or adhesive activation as recommended by the film manufacturer to reduce trapped air and allow conforming to curves. Use a soft squeegee to smooth the film from the center outward and trim any excess if necessary. Allow the adhesive to cure according to the manufacturer’s guidance before exposing the vehicle to heavy wash cycles or high-pressure cleaners.

Usage recommendations

For best results, install at temperatures recommended by the film manufacturer (typically moderate ambient temperatures) and avoid direct sunlight during fitting. If unsure about achieving a seamless finish, consider professional installation to ensure full adhesion and correct alignment. Regularly wash the protected lenses with mild soap and water and avoid abrasive cleaners to maintain the film’s clarity and protective properties.