Protective film GrizzGlass BodyShield for Skoda Superb II facelift (2013–2015) — door sills set 4-in-1

GrizzGlass BodyShield protective film for Skoda Superb II facelift (2013–2015) is a precision-cut door sill set that protects entrance areas from scratches, scuffs and wear. The transparent, thin film preserves the original appearance of the sills while providing a durable barrier against everyday damage caused by footwear, luggage and loading. Pre-cut pieces follow the factory sill contours to simplify alignment and ensure a discrete fit that does not interfere with vehicle aesthetics.

Advantages

The film is virtually invisible once applied, maintaining the factory finish and color of the sill while offering reliable surface protection. Its thin construction allows doors to close normally and retains original trim edges without adding bulk. The pre-cut design reduces installation time and helps achieve an accurate fit without trimming. The material resists scratching and abrasion, extending the life of painted entry surfaces and reducing the need for cosmetic repairs.

Suitable for

• Protecting door sills from shoe scuffs and heel marks
• Preventing paint chips and scratches during loading and unloading
• Maintaining resale value by keeping visible entry areas in good condition
• DIY installation during vehicle detailing or refurbishment

Key specifications

• Compatibility: Skoda Superb II facelift models produced between 2013 and 2015
• Package contents: door sill set with four pre-cut film pieces
• Material: thin, transparent protective film designed for automotive exterior surfaces
• Finish: clear, low-profile surface that preserves original sill appearance
• Protection type: scratch and abrasion resistance for entry areas

How to use

Prepare the sill surfaces by cleaning thoroughly with a mild detergent and a lint-free cloth to remove dirt, grease and residues. Align each pre-cut film piece to the corresponding sill panel to verify fit before removing the adhesive backing. Apply the film starting from one edge, smoothing outward to avoid air bubbles and wrinkles; use a soft squeegee if available. Allow the adhesive to set according to ambient temperature and avoid washing the car or exposing the area to heavy moisture for the first 24 hours to ensure optimal adhesion.

Usage recommendations

For best results, install at temperatures between 15–25°C on dry, dust-free surfaces. If small air pockets remain after application, gently lift the nearest edge and reapply while smoothing. When removing the film, warm the area with a heat source and peel slowly to minimize adhesive residue; any remaining residue can be removed with an automotive-safe adhesive remover.