Protective pillar film GrizzGlass BodyShield for Peugeot 308 Estate (2013–2021) 6-in-1 set

GrizzGlass BodyShield protective pillar film set for Peugeot 308 Estate (2013–2021) is a pre-cut, transparent exterior film designed to cover vehicle pillars and trim areas prone to scratches, chips and everyday wear. The 6-in-1 kit contains shaped adhesive pieces that follow the contours of the specified model years, delivering a close fit that preserves the car’s original look while adding a discreet protective layer. The films are intended for external use on painted and trim surfaces and can be installed by a competent DIYer or by a professional installer.

Advantages

The films provide a clear protective barrier that reduces the risk of stone chips, door-swing scuffs and abrasion without changing the appearance of the vehicle. Pre-cut pieces save trimming time and ensure consistent coverage for each pillar area. The adhesive is formulated for outdoor exposure and long-term adhesion, while the thin, conformable material enables a near-invisible finish. Designed specifically for the Peugeot 308 Estate (2013–2021), the kit minimizes gaps and overlaps that can occur with universal products.

Suitable for

• Protecting A-, B- and C-pillars from scratches and chips
• Preserving glossy or painted trim areas on the exterior
• DIY installation or professional fitting during detailing or bodywork
• Vehicles exposed to frequent urban driving or gravel/stone roads

Key specifications

• Material: transparent protective film suitable for exterior use
• Configuration: 6-piece pre-cut set shaped for Peugeot 308 Estate (2013–2021)
• Finish: clear, low-gloss to near-invisible after application
• Adhesive: pressure-sensitive outdoor-grade adhesive formulated for painted surfaces
• Thickness: thin, conformable film designed to follow contours and edges
• Application area: vehicle pillars and adjacent trim surfaces

How to use

Prepare the vehicle by thoroughly cleaning and degreasing the pillar and trim areas to remove wax, silicone and contaminants. Test-fit each pre-cut piece to confirm alignment, then peel the backing and position the film carefully. Use a squeegee and moderate pressure to smooth the film and remove trapped air and moisture, paying attention to edges and seams. When required, apply heat gently with a heat gun or infrared lamp to aid conforming around curves, then trim any excess if needed. Allow the adhesive to cure according to ambient conditions before washing or exposing the car to heavy weather.

Usage recommendations

For best results, install at temperatures above 15°C on a clean, dry surface and avoid automated high-pressure washes for the first 48–72 hours. If unsure about complex curves, professional installation is recommended to ensure seamless adhesion and long-term performance.