Protective Door Sill Film GrizzGlass BodyShield for Peugeot 3008 (2016–2024) 4-piece set

GrizzGlass BodyShield for Peugeot 3008 (2016–2024) is a 4-piece protective door sill film set designed to preserve the original paint and finish of vehicle door sills. The thin transparent self-adhesive films cover high-contact areas where shoes and luggage commonly cause abrasion, helping to prevent scratches, scuffs and wear without altering the visual appearance of the car. The set is suitable for professional workshops as well as careful DIY installation by vehicle owners.

Advantages

The film is made from a durable, thin transparent material that provides surface protection while remaining almost invisible. Its self-adhesive backing allows secure attachment to door sills and resists lifting and edge peeling under normal use. Because the material is thin and flexible, it follows contours and retains the factory look of the Peugeot 3008. The films are easy to clean and do not require paints or solvents, so they maintain the original finish without chemical alteration.

Suitable for

• Protecting front and rear door sills from scratches and scuffs
• Maintaining factory paint condition during daily use
• Use in professional fitting shops or for DIY installation
• Owners who want near-invisible protection without aesthetic changes

Key specifications

• Quantity: 4-piece set sized for Peugeot 3008 doors
• Material: thin transparent protective film
• Adhesive: permanent self-adhesive backing for secure fit
• Finish: clear, low-visibility surface
• Application area: door sills (front and rear)

How to use

Before application, clean the door sill surface thoroughly with isopropyl alcohol or a mild detergent and allow it to dry completely. Carefully position the film piece on the sill to check alignment, then peel the backing and apply from one edge to the other, smoothing out air bubbles with a soft squeegee or cloth. For curved or recessed areas, gently heat the film with a heat gun or hairdryer at low setting to increase flexibility and ensure full adhesion. Trim any excess material if necessary, and allow the adhesive to cure for 24 hours before exposing the sill to heavy wear or moisture.

Usage recommendations

For best results, install the film at ambient temperatures between 15–25°C and avoid washing the vehicle or exposing treated areas to high-pressure streams for at least 24 hours after application. Where possible, seek professional installation if exact alignment or edge treatment is required.