Trunk Sill Protector Film GrizzGlass BodyShield for MG ZS Hybrid+ 2024–2025, carbon-look

The GrizzGlass BodyShield trunk sill protector film for MG ZS Hybrid+ (model years 2024–2025) is a vehicle-specific carbon-look film designed to shield the rear loading edge from everyday wear. The film follows the sill contour to provide full coverage of the most exposed area during loading and unloading, helping to preserve the original paint finish and reduce the risk of scratches, scuffs and minor impact marks. The surface imitates carbon fiber for a discreet, utilitarian appearance while remaining thin and flexible so it integrates with the bumper geometry.

Advantages

This trunk sill protector film is tailored to the MG ZS Hybrid+ rear sill shape for accurate fit and clean edges without trimming. It provides surface protection against abrasive contact and small impacts, helping maintain vehicle resale value and finish. The carbon-look surface offers a non-reflective, practical appearance that hides light wear, while the adhesive backing is formulated for secure adhesion and long-term durability on painted surfaces. Installation is straightforward and reversible without damaging factory paint when removed correctly.

Suitable for

• Daily luggage and grocery loading and unloading
• Transport of suitcases, boxes and sports equipment
• Protection during occasional heavy or abrasive cargo handling
• Preserving paint at the rear loading edge for resale or lease return

Key specifications

• Vehicle compatibility: MG ZS Hybrid+ model years 2024–2025
• Material: protective polymer film with carbon-look finish
• Surface: textured carbon-effect appearance, non-reflective
• Form factor: pre-cut to vehicle-specific sill shape for direct application
• Thickness: thin, flexible film designed to conform to bumper contours
• Adhesive: pressure-sensitive backing formulated for painted surfaces
• Function: protects against scratches, scuffs and minor impacts at loading edge

How to use

Clean the trunk sill thoroughly to remove dirt, grease and moisture before installation. Peel the protective liner from the adhesive backing and align the film with the loading edge, starting from one side and smoothing it across to avoid air bubbles. Use steady pressure to secure the film along the entire sill and allow time for the adhesive to set according to ambient temperature. If necessary, heat with a low-temperature heat source to help the film conform to complex curves, and trim any excess only if a precise fit requires it.

Usage recommendations

For best results, install at moderate ambient temperatures and on a clean, dry surface. Avoid high-pressure washing directly at the film edges for the first 24–48 hours to allow the adhesive to fully cure. When removing the film, warm the adhesive with a heat source and peel slowly to minimize risk to the underlying paint.