GrizzGlass BodyShield black pillar film for Lexus ES 300h (2021–2024) 4-piece set

GrizzGlass BodyShield black pillar film for Lexus ES 300h (2021–2024) 4-piece set is a pre-cut exterior trim protection kit designed to cover the B-pillars of the specified Lexus model years. Each set contains four shaped pieces that match the contours of the vehicle’s B-pillars to provide a consistent black finish while protecting the original surface from light scratches, scuffs and everyday wear. The film is intended for precise application on the listed model years to ensure alignment with trim lines and door seams.

Advantages

The GrizzGlass BodyShield pillar film delivers surface protection without permanently altering the underlying trim. Its pre-cut design simplifies installation and reduces trimming errors, while the matte/black finish creates a uniform look across both sides of the vehicle. The film helps resist minor abrasion and preserves factory paint and trim appearance. Because pieces are matched to the B-pillar shape, the finished result appears factory-integrated and maintains door operation and sealing when applied correctly.

Suitable for

• Owners of Lexus ES 300h model years 2021–2024 seeking exterior trim protection
• People who want a uniform black look on B-pillars without repainting
• Light scratch and scuff protection for daily-driven vehicles
• DIY installers and professional wrap shops requiring pre-cut, vehicle-specific pieces

Key specifications

• Material: durable automotive-grade protective film suitable for exterior use
• Finish: black, designed to match exterior trim appearance
• Pieces included: four pre-cut pieces shaped for B-pillars
• Fitment: engineered to align with door seams and pillar contours of Lexus ES 300h 2021–2024
• Protection: guards against light scratches, scuffs and surface wear

How to use

Before application, clean the B-pillar surfaces thoroughly to remove dirt, grease and wax, and ensure the area is dry and at moderate temperature. Position each pre-cut piece on the corresponding pillar to verify fit, then peel the backing and apply the film from one edge, smoothing out air bubbles and wrinkles with a squeegee or soft applicator. Use a heat gun or hair dryer on low heat if needed to conform the film into tight contours, taking care not to overheat. Trim any excess only if necessary and press edges firmly to secure adhesion. Allow the adhesive to set according to ambient conditions before exposing the vehicle to heavy washing or extreme weather.

Usage recommendations

For best results, apply the film in a clean, dust-free environment and at temperatures between 15–25 °C. If uncertain about fit or complex contours, consider professional installation to ensure seamless alignment and long-term adhesion. Clean the protected surfaces with a mild, non-abrasive cleaner and avoid high-pressure washers directly at the film edges during the first 48 hours after application.