Paint protection film GrizzGlass BodyShield for Audi A4 Avant (2019–2024) — carbon finish, set for pillar trims [10-in-1]

GrizzGlass BodyShield paint protection film for Audi A4 Avant (2019–2024) — carbon finish, set for pillar trims [10-in-1] is a pre-cut protective coating designed to fit the pillar trims and adjacent body panels of the specified Audi A4 Avant model years. The kit comes as a 10-piece set that follows the original contours of the vehicle to cover high-contact vertical surfaces and nearby edges. The carbon finish provides a textured visual effect while the film’s composition focuses on preventing minor damage from scratches, stone chips and abrasion without altering trim fitment.

Advantages

The GrizzGlass BodyShield film offers a combination of mechanical protection and a carbon-style surface that resists superficial marks and impact from road debris. Its pre-cut design reduces trimming and adjustment time during installation. The film is engineered to conform to curved and narrow areas around pillars while maintaining clarity and adhesion over time. This solution preserves the vehicle’s original trim lines and can be applied by a competent DIYer or by a professional installer for a precise finish.

Suitable for

• Owners of Audi A4 Avant (model years 2019–2024) seeking protection for pillar trims
• Protecting vertical trim areas from stone chips and parking-related scratches
• DIY fitting in a controlled, dust-free environment or professional workshop installation

Key specifications

• Finish: carbon textured surface
• Kit contents: 10 pre-cut pieces designed for pillar trims and adjacent edges
• Compatibility: tailored for Audi A4 Avant (2019–2024) pillar trim geometry
• Protection: resists scratches, stone chips and abrasion on exposed vertical surfaces
• Material properties: flexible, conformable film with pressure-sensitive adhesive backing
• Installation: suitable for wet or dry installation techniques depending on installer preference

How to use

Prepare the vehicle surface by thoroughly cleaning and degreasing the pillar trims and surrounding areas; remove wax, polish residues and contaminants. Position each pre-cut piece to verify fit before removing liner. For wet installation, apply a slip solution to the adhesive surface or vehicle substrate to allow repositioning, then align and squeegee from the center outward to expel solution and air. For dry installation, peel the backing gradually and apply with controlled pressure to avoid trapping air. Trim any excess where necessary and allow the adhesive to cure according to ambient temperature instructions. Avoid full exposure to water or high-pressure washing for the initial curing period.

Usage recommendations

Apply in a clean, temperature-controlled area (ideally 15–25°C). Use a soft squeegee and low-stretch tape for alignment. If unsure about fitment or to achieve optimal edge finishing, consider professional installation. Clean the film with a pH-neutral car shampoo and soft microfiber; avoid abrasive cleaners or aggressive solvents that could degrade the finish or adhesive.