Trim film GrizzGlass BodyShield carbon for pillar covers for Mitsubishi ASX Facelift (2024-2025) set 10-in-1

GrizzGlass BodyShield carbon trim film is made for pillar covers on the Mitsubishi ASX Facelift (2024–2025). This adhesive film set contains ten pre-cut pieces sized and shaped to match exterior pillar trims, offering a carbon-look surface that refreshes appearance while providing a protective layer against light surface wear and minor scratches. The product is intended for DIY fitting on vehicle pillars and is compatible with the ASX Facelift pillar geometry when applied according to instructions.

Advantages

The film delivers a consistent carbon finish that conceals existing minor imperfections and restores uniform appearance across pillar trims. Its adhesive backing enables direct application without the need for additional fasteners, while the flexible material conforms to common pillar contours. The set of ten pieces allows coverage of multiple pillars or replacement of individual sections, and the surface resists light abrasion and fading under normal outdoor conditions.

Suitable for

• Owners of Mitsubishi ASX Facelift (2024–2025) seeking to refresh exterior pillar trims
• DIY vehicle detailers performing exterior trim renewals or cosmetic upgrades
• Drivers who want to protect pillars from light scratches and surface wear
• Workshops performing small-scale exterior trim repairs without repainting

Key specifications

• Finish: carbon-look decorative film
• Set contents: 10 pre-cut adhesive pieces for pillar covers
• Material properties: flexible adhesive-backed trim film designed to conform to curved surfaces
• Primary function: cosmetic renewal and surface protection against light abrasion
• Compatibility: designed to fit pillar trims of Mitsubishi ASX Facelift model years 2024–2025

How to use

Before application, clean the pillar surfaces thoroughly to remove dirt, wax and oils; a degreaser or isopropyl alcohol is recommended for best adhesion. Align the corresponding pre-cut piece with the pillar cover, peel back a portion of the release liner and position the film starting from one edge. Smooth the film progressively toward the opposite edge using a soft squeegee or cloth to avoid air bubbles and ensure full contact with the substrate. Trim any excess material if necessary and apply firm pressure along edges for final adhesion. Allow the adhesive to set for the period specified in the included instructions before exposing the treated area to heavy washing or extreme conditions.

Usage recommendations

Perform application at moderate ambient temperatures (typically 15–25°C) and avoid direct sunlight during fitting to improve handling and adhesion. For best results, allow the vehicle surface to reach room temperature and handle curved sections slowly to prevent creasing. If removing existing film, heat with a heat gun or hair dryer to soften adhesive before peeling. Store unused pieces flat in a cool, dry place to preserve adhesive performance.