Protective carbon-style pillar film GrizzGlass BodyShield for Tesla Model Y Juniper (2024–2025) [4-in-1]

GrizzGlass BodyShield protective carbon-style pillar film for Tesla Model Y Juniper (2024–2025) is a four-piece kit designed to cover the vehicle's door pillars and pillar trim panels. The film follows original contours and provides a discreet textured carbon appearance while preserving the factory paint beneath. It is cut for precise fit on Model Y pillar sections and intended to reduce visible damage from scratches, stone chips and everyday wear without altering the vehicle's finish.

Advantages

The GrizzGlass BodyShield film offers a durable, flexible layer that resists minor impacts and abrasion while remaining thin and unobtrusive. Its carbon-style surface masks small imperfections and adds consistent coverage across pillar panels. The kit's pre-cut pieces enable accurate alignment and minimize trimming during installation. The film is also designed for easy maintenance, allowing cleaning and care similar to painted surfaces without risking delamination when used as directed.

Suitable for

• Owners of Tesla Model Y Juniper model years 2024–2025 seeking pillar protection
• Vehicles frequently exposed to city driving where stone chips and door nicks are common
• Detailers and professional installers performing cosmetic protection upgrades
• Users who prefer a textured carbon-style look while maintaining original paint

Key specifications

• Material: multilayer protective film with carbon-style surface texture
• Kit configuration: four pre-cut pieces covering door pillar panels
• Finish: textured carbon-style appearance designed to be discreet
• Thickness: low-profile protective layer suitable for pillar contours
• Adhesive: pressure-sensitive adhesive formulated for automotive paint compatibility
• Durability: engineered to resist scratches, minor impacts and abrasion

How to use

Prepare the vehicle by thoroughly washing and decontaminating the pillar areas. Ensure panels are dry and free of wax, grease or road film. Position each pre-cut piece on the corresponding pillar panel to check fit before removing backing. Apply the film gradually, using a soft squeegee to remove air and ensure adhesion, working from the center outward. Heat may be applied carefully with a low-temperature heat gun or infrared heater to conform the film to curved sections; avoid excessive heat. Trim any excess if necessary and allow adhesive to set according to ambient temperature recommendations.

Usage recommendations

If professional installation is preferred, consult a trained installer to ensure optimal fit and longevity. Clean the film with gentle automotive detergents and a soft microfiber cloth; avoid abrasive cleaners and strong solvents. Inspect edges periodically and, if damage occurs, replace the affected piece to maintain protection.