Tint Film GrizzGlass BodyShield for BMW 3 Series E92 Coupe LCI (2010–2013) — Black pillar protection [2-in-1]

GrizzGlass BodyShield black tint film made for BMW 3 Series E92 Coupe LCI (2010–2013) provides tailored pillar protection and visual darkening for the vehicle's exterior trim. Supplied as a 2-in-1 kit, the film is cut to fit door pillars and adjacent trim areas, preserving the original contours and mounting points while delivering a seamless darkened appearance. The material is engineered for exterior automotive use and is intended to reduce glare from bright sunlight and complement the car's factory lines.

Advantages

The film is precisely shaped for the BMW E92 LCI coupe, which simplifies alignment and reduces trimming during installation. Its black tint offers consistent visual darkening without altering the underlying surfaces, and the protective layer guards pillars and trim against minor scratches, UV exposure and surface wear. Because the kit is 2-in-1, it contains pieces for both pillars and adjacent trim to achieve a uniform finish across door openings.

Suitable for

• Pillar protection on BMW 3 Series E92 Coupe LCI (2010–2013)
• Reducing glare and bright reflections on exterior trim
• Improving visual continuity and darkening of door pillar areas
• DIY or professional fitting where a pre-cut kit is preferred

Key specifications

• Vehicle fitment: BMW 3 Series E92 Coupe LCI (2010–2013)
• Application area: exterior door pillars and adjacent trim
• Finish: black tint for visual darkening
• Kit type: 2-in-1 pre-cut pieces for precise alignment
• Material properties: weather-resistant automotive-grade film with protective surface

How to use

Clean the pillar and trim surfaces thoroughly with isopropyl alcohol or a recommended automotive cleaner to remove dirt, wax and oils. Position the pre-cut film pieces on the corresponding pillar and trim areas to confirm fit before removing the backing. Apply the film starting from one edge, smoothing it into place with a soft squeegee to expel trapped air and ensure firm adhesion. Trim any excess if necessary and allow the adhesive to set according to ambient temperature guidelines. If unsure, consult a professional installer experienced with exterior automotive films.

Usage recommendations

For best results, perform installation in a dust-free environment at moderate temperature (15–25°C). Avoid high-pressure car washes for 48–72 hours after fitting to allow full adhesive curing. Periodically inspect edges for lifting and clean with non-abrasive cleaners to preserve appearance and adhesion.