Protective pillar film GrizzGlass BodyShield for Volkswagen Passat B5 Sedan Facelifting (2000–2005) — black, set 6-in-1

GrizzGlass BodyShield black pillar film set is designed specifically for Volkswagen Passat B5 Sedan Facelifting (2000–2005). The kit includes six precut pieces that fit exterior B-pillars and pillar trims to protect painted surfaces from scratches, stone chips and daily wear. The black finish integrates with factory trim, providing a low-profile protective layer that preserves the vehicle’s appearance while remaining virtually invisible at normal viewing distances.

Advantages

The film is manufactured from durable, abrasion-resistant material that resists tearing and maintains adhesion under outdoor conditions. Its tailored shape for the Passat B5 Facelifting ensures accurate coverage with minimal trimming. The black colour masks existing minor blemishes and creates a consistent visual line on the pillar area. The kit approach simplifies replacement and allows individual pieces to be replaced if damaged without removing the entire assembly.

Suitable for

• Protecting exterior B-pillars and pillar trims on Volkswagen Passat B5 Sedan Facelifting (2000–2005)
• Preventing scratches from keys, bags and passenger ingress/egress
• Reducing stone chip damage in high-traffic or rural environments
• Cosmetic repair or concealment of minor existing marks on pillar surfaces

Key specifications

• Colour: black
• Kit composition: 6 precut film pieces for exterior pillar coverage
• Material: flexible, abrasion-resistant protective film
• Surface finish: matte/low-reflective black designed to match trim
• Adhesive: pressure-sensitive aftermarket adhesive suitable for automotive paint
• Fitment: tailored to Volkswagen Passat B5 Sedan Facelifting model years 2000–2005

How to use

Prepare the pillar surfaces by thoroughly cleaning and degreasing with an appropriate automotive cleaner, removing wax and contaminants to ensure firm adhesion. Position each precut film piece on the pillar to confirm alignment before removing the protective backing. Apply the film gradually from one edge to the other, smoothing out air bubbles with a soft squeegee or cloth while maintaining even pressure. If necessary, use a heat gun at low temperature to conform the film around curves and edges, taking care not to overheat the paint. Trim any excess material only if required and allow the adhesive to set according to ambient temperature recommendations.

Usage recommendations

For best results, apply the film in a clean, dust-free environment at moderate temperature (typically 15–25°C). Avoid car washes, high-pressure cleaning, or chemical solvents on the treated area for at least 48 hours after installation to allow the adhesive to fully bond. Regularly inspect edges and reapply pressure if lifting occurs; damaged sections can be replaced individually from the kit.