Trunk sill protector film GrizzGlass BodyShield for BMW 3 Series F30 Sedan Pre-LCI (2011–2015) – carbon pattern

GrizzGlass BodyShield trunk sill protector film for BMW 3 Series F30 Sedan Pre-LCI (2011–2015) is a self-adhesive protective layer with a carbon pattern designed to cover the rear bumper edge and trunk sill. It fits the specified model’s trunk opening contours to protect factory paint from scratches, scuffs and minor impacts that occur during loading and unloading. The film provides a durable surface finish while preserving the vehicle’s original appearance and can be removed without damaging underlying paint when replacement is required.

Advantages

The GrizzGlass BodyShield film offers a precise fit for the BMW 3 Series F30 Sedan Pre-LCI (2011–2015) trunk sill and a textured carbon-pattern surface that hides wear while resisting abrasion. Its strong self-adhesive backing ensures long-term adhesion under normal environmental conditions, and the thin flexible material conforms to the trunk edge without creating visible seams. The protector reduces the risk of chips and scratches during routine cargo handling and maintains the original contours of the bumper.

Suitable for

• Protecting the trunk sill and rear bumper edge during loading and unloading
• Owners who want to preserve factory paint against scratches and scuffs
• Vehicles used for transporting luggage, sports equipment or shopping
• Cosmetic refresh when original sill shows minor wear but paint is intact

Key specifications

• Compatibility: Designed for BMW 3 Series F30 Sedan Pre-LCI (2011–2015)
• Finish: Carbon pattern textured surface
• Material: Flexible protective film with durable wear-resistant face
• Adhesive: Pressure-sensitive self-adhesive backing for secure fit
• Coverage: Tailored to the trunk sill and rear bumper edge contours
• Thickness: Low-profile film that preserves factory lines and contours

How to use

Before installation, clean the trunk sill thoroughly with a mild degreaser and allow the surface to dry. Test-fit the film to confirm alignment with the trunk edge. Remove the protective liner and apply the film starting from one side, smoothing across the surface to avoid trapped air. Use a soft squeegee or cloth to press the film into place and ensure adhesion along the contours. Allow the adhesive to set for the recommended time at moderate temperatures before exposing the area to heavy use.

Usage recommendations

For best results, install the film in a dust-free environment at temperatures between 15–25°C. Avoid washing the area with high-pressure washers directly at the film edge for 24–48 hours after fitting. If removal is needed, warm the film slightly with a heat source and peel slowly at a low angle to minimize residue; any remaining adhesive can be removed with an appropriate solvent following manufacturer guidance.