Trunk Sill Protector GrizzGlass BodyShield for BMW 5 Series F10 Sedan PreLCI (2010–2012) – carbon-look film

GrizzGlass BodyShield trunk sill protector is a carbon-look adhesive film made to fit the rear bumper sill area of the BMW 5 Series F10 Sedan PreLCI (2010–2012). The film covers the loading edge to prevent scratches, scuffs and wear caused by luggage, tools and everyday loading. Manufactured as a durable and flexible covering, it conforms to original bumper contours and preserves the factory finish while remaining removable if needed.

Advantages

The carbon-look film provides a hardwearing surface that resists abrasion and light impacts, helping to maintain the vehicle’s resale value by protecting the paint and trim at the trunk opening. Its adhesive backing allows for a close fit to OEM surfaces and simple trimming to achieve precise coverage. The material is flexible enough to follow curves and edges while offering long-term durability against typical loading wear.

Suitable for

• BMW 5 Series F10 Sedan PreLCI models produced 2010–2012
• Protecting the rear bumper sill from luggage-related scratches and scuffs
• Owners who prefer a carbon-look finish on the trunk loading edge
• Applications where a removable, non-invasive protective film is required

Key specifications

• Material: carbon-look adhesive film with flexible backing
• Fitment: shaped to cover rear bumper trunk sill area for BMW 5 Series F10 Sedan PreLCI (2010–2012)
• Surface compatibility: designed for OEM painted bumper and trim surfaces
• Protection type: abrasion and scuff resistance for loading edge
• Installation: applied with adhesive backing, trimmable for precise fit
• Finish: textured carbon-look appearance

How to use

Ensure the trunk sill area is clean, dry and free of wax, grease or loose debris before application. Position the film on the bumper sill to check alignment and trim any excess material where necessary. Peel the adhesive backing gradually while smoothing the film into place, using a soft applicator to remove air pockets and ensure even adhesion. Allow the adhesive to set according to ambient temperature; avoid heavy loading for several hours after installation to ensure full bonding.

Usage recommendations

For best results, apply the film at moderate temperatures (approximately 15–25°C) on a clean, dust-free surface. If trimming, use a sharp knife and a straight edge to achieve clean edges. To remove, gently lift a corner and peel back slowly at a low angle; any residual adhesive can be removed with a suitable adhesive remover that is safe for painted surfaces. Regularly inspect the protected area and clean with mild soap and water to maintain appearance.