Protective carbon-look pillar film GrizzGlass BodyShield for Audi A6 C6 Sedan 4D (2004–2008) set 4 pieces

GrizzGlass BodyShield protective carbon-look pillar film is a four-piece set tailored for the Audi A6 C6 Sedan 4D (2004–2008). Each pre-cut film is shaped to cover the vehicle's B-pillars, offering an exterior trim protection layer that resists light scratches, scuffs and everyday wear. The films have a carbon-fiber appearance to match sporty or refined styling while preserving the underlying paint and trim surfaces. The adhesive backing is formulated for direct application onto exterior pillars and designed for a flush fit with the original body lines.

Advantages

The GrizzGlass BodyShield set combines protective function with a consistent carbon-look finish across both B-pillars. Pre-cut pieces eliminate the need for trimming and simplify alignment, reducing installation time compared with generic film rolls. The adhesive is engineered to adhere to automotive exterior surfaces while allowing for smooth, bubble-minimised application. The film provides a reversible, non-permanent cosmetic upgrade and adds a discrete protective barrier against everyday abrasion.

Suitable for

• Protecting B-pillars on Audi A6 C6 Sedan 4D (2004–2008) from scratches and scuffs
• Cosmetic enhancement to achieve a carbon-fiber appearance on exterior pillars
• Do-it-yourself exterior trim protection without professional cutting
• Preserving original paint and trim during daily use or urban driving

Key specifications

• Quantity: set of 4 pre-cut pillar films
• Fitment: shaped for Audi A6 C6 Sedan 4D B-pillars (2004–2008)
• Finish: carbon-look (textured appearance resembling carbon-fibre)
• Adhesive type: automotive-grade pressure-sensitive adhesive for exterior use
• Application area: exterior B-pillars

How to use

Thoroughly clean the target pillar surfaces to remove dirt, grease and wax, then dry completely. Position the pre-cut film without removing the backing to confirm alignment, then peel the adhesive liner gradually while applying the film from one edge to the other. Use a soft squeegee or a lint-free cloth to smooth the film and expel trapped air, working from the centre toward the edges. Trim any excess only if necessary and press firmly along the borders to ensure full adhesion. Allow the adhesive to set according to ambient temperature before exposing the vehicle to heavy washing or extreme conditions.

Usage recommendations

For best results, apply at temperatures between 15–25°C on a calm day, avoid rain or high humidity during installation, and wait 24–48 hours before subjecting the area to high-pressure washing. If removing the film later, warm the adhesive with a heat gun or hair dryer to reduce residue and peel gently along the film’s length.