Protective carbon-look pillar film GrizzGlass BodyShield for Audi A6 C7 Avant Facelifting (2014–2018) set 10-in-1

GrizzGlass BodyShield carbon-look pillar film for Audi A6 C7 Avant Facelifting (2014–2018) is a pre-cut protective film set designed to cover the vehicle's vertical pillars. The self-adhesive film provides a textured carbon finish that integrates with exterior trim while protecting painted and plastic pillar surfaces from scratches, chips and everyday wear. This 10-in-1 set includes all pieces required to cover the common pillar areas of the Avant Facelifting model for consistent visual protection.

Advantages

The film combines a carbon-look surface with a durable protective layer that resists minor impacts and abrasion without altering door function or visibility. Its self-adhesive backing allows direct application to paint and trim, reducing the need for additional fasteners or adhesives. Designed specifically for the Audi A6 C7 Avant Facelifting (2014–2018), the pre-cut pieces simplify alignment and ensure repeatable coverage across all vehicle pillars. The finish helps maintain a uniform exterior appearance and reduces the frequency of touch-up work caused by chips and scuffs.

Suitable for

• Protecting vertical pillars of Audi A6 C7 Avant Facelifting (2014–2018) from scratches and chips
• Maintaining consistent exterior trim appearance with a carbon-look finish
• Reducing minor surface damage from daily use, parking, and loading
• DIY or professional exterior trim protection installations

Key specifications

• Application area: vertical vehicle pillars (pre-cut pieces for Audi A6 C7 Avant Facelifting 2014–2018)
• Quantity: 10 pieces (10-in-1 set) covering pillar surfaces
• Material finish: carbon-look textured surface
• Attachment: self-adhesive backing suitable for painted surfaces and trim
• Primary function: scratch, chip and abrasion protection for exterior pillar areas

How to use

Clean the pillar surfaces thoroughly to remove dirt, grease and wax using an appropriate cleaner. Align each pre-cut film piece on the corresponding pillar area to confirm fit before removing the backing. Peel the adhesive liner gradually and press the film onto the surface, smoothing from the center outward to eliminate air pockets and ensure full contact. Trim any excess if necessary and allow the adhesive to set according to ambient temperature recommendations. Avoid washing or exposing the area to heavy moisture immediately after application to maximize adhesion.

Usage recommendations

For best results, perform the installation at moderate temperatures on a clean, dry vehicle. If available, use a soft squeegee and heat gun at low setting to conform the film around curves and improve adhesion. For long-term maintenance, clean the film with mild soap and water; avoid abrasive cleaners and strong solvents that can degrade the finish or adhesive.