GlassProtect GrizzGlass BodyShield carbon-look pillar film for Skoda Superb 2 Facelifting (2013–2015) 6-in-1

GlassProtect GrizzGlass BodyShield carbon-look pillar film for Skoda Superb 2 Facelifting (2013–2015) 6-in-1 is a pre-cut exterior trim protection kit designed to cover the B-pillars and adjacent door pillar areas. The kit replicates a carbon finish while providing a thin protective layer that reduces surface wear and shields painted or plastic pillars from scratches, scuffs and daily exposure to the elements. Intended for a precise fit on the Skoda Superb 2 Facelifting (2013–2015), the set contains six pieces that follow the contour of the vehicle’s pillars for a near-factory appearance with a textured carbon-look surface.

Advantages

The GrizzGlass BodyShield film offers durable surface protection combined with an authentic carbon-look texture. Its pre-cut shape simplifies installation and ensures alignment with factory trim lines, reducing the need for on-site trimming. The film is thin and conformable to curved surfaces, resists minor abrasions and helps prevent paint damage from keys, belts and routine contact. The carbon-look finish provides a consistent visual upgrade without permanent modification to the vehicle’s exterior.

Suitable for

• Protection of B-pillars and door pillar trims on Skoda Superb 2 Facelifting (2013–2015)
• Preventing scratches and scuffs from daily use and ingress/egress
• Visual enhancement to imitate a carbon-fiber appearance on exterior pillars
• Owners seeking a removable, non-destructive exterior trim upgrade

Key specifications

• Material: durable conformable protective film with carbon-look surface
• Finish: textured carbon-look (matte or low-sheen appearance)
• Pieces: 6 pre-cut elements shaped for door pillars and surrounding areas
• Compatibility: specifically shaped for the Skoda Superb 2 Facelifting (2013–2015) pillar geometry
• Thickness: thin protective film designed for adhesion and contouring (flexible)
• Application area: external B-pillars and adjacent pillar trims

How to use

Prepare the installation area by thoroughly cleaning the pillars and surrounding surfaces to remove dirt, wax and grease. Align each pre-cut piece with the corresponding pillar section and progressively apply the film from one edge, using light pressure or a soft squeegee to smooth out air pockets and ensure full adhesion. For curved sections, gently heat the film with a heat gun or warm air to increase flexibility, then conform it to the profile. Trim any excess if necessary and allow adhesion to set according to ambient temperature recommendations.

Usage recommendations

For best results, install the film on a clean, dry surface at moderate ambient temperature. Avoid high-pressure car washes or aggressive chemical cleaners for the first 24–48 hours to allow the adhesive to cure. If removal is required, warm the film to soften the adhesive and peel slowly to minimize residue on the pillar surface.