Interior Film GrizzGlass PianoSkin Glossy for Audi A7 C8 (2018–2025) — Set for 11 Parts

GrizzGlass PianoSkin Glossy interior film for Audi A7 C8 (2018–2025) is a pre-cut 11-piece set designed to fit the dashboard and trim surfaces. The film provides a high-gloss piano black finish that refreshes cabin appearance while adding a protective layer to original panels. Each piece is shaped to match common trim components in the A7 C8 interior, allowing for full-surface coverage of key dashboard and console areas without permanent alteration to factory parts.

Advantages

The PianoSkin Glossy film delivers a uniform, reflective surface that reduces the appearance of minor scratches and surface imperfections. Made from automotive-grade vinyl, the film resists everyday wear and shields panels from scuffs, fingerprints and UV-related fading. The pre-cut design simplifies alignment and reduces trimming; the film can be removed later without leaving adhesive residue when installed correctly.

Suitable for

• Owners of Audi A7 C8 (model years 2018–2025) seeking an interior visual upgrade
• DIY installers who want a plug-and-play solution for dashboard and trim refresh
• Professional fitters performing surface protection or styling modifications
• Vehicles requiring protection of glossy surfaces from scratches and daily wear

Key specifications

• Finish: high-gloss piano black
• Material: automotive-grade vinyl film
• Set composition: 11 pre-cut parts covering dashboard and trim areas
• Surface protection: resistance to light scratches, fingerprints and mild abrasion
• Removal: designed for non-destructive removal when heated and peeled correctly

How to use

Clean and degrease the installation surfaces thoroughly before applying the film to ensure proper adhesion. Align each pre-cut piece with the corresponding trim panel, apply gradually while smoothing with a soft squeegee or microfiber to avoid air bubbles, and use controlled heat from a heat gun to conform the film to complex curves and edges. Trim any small excess with a sharp knife if necessary and allow the adhesive to cure according to ambient temperature guidelines.

Usage recommendations

For best results, install at room temperature on a clean, dry vehicle interior. Start with larger central pieces to establish alignment, then fit surrounding trims. Use low to moderate heat when stretching around curves and check edges after 24 hours to ensure full adhesion. Avoid high-pressure car washes and abrasive cleaners during the initial curing period.