Interior Film GrizzGlass PianoSkin Glossy for Peugeot 508 (2010–2018) — 4-in-1 set

GrizzGlass PianoSkin Glossy interior film specifically cut for Peugeot 508 (2010–2018) is a 4-in-1 set designed to cover and protect multiple trim panels inside the cabin. The glossy piano-black finish restores a uniform look to dashboard and console surfaces while concealing minor scratches and signs of wear. The film is intended for overlay application on factory plastic and trim parts to provide a low-profile decorative coating without permanent alteration to the original panels.

Advantages

The glossy film delivers a consistent piano-black appearance that hides light imperfections and evens out differing surface textures. Its thin, conformable construction allows it to follow curved dashboard and console contours while maintaining adhesion. The product offers surface protection against light abrasions and everyday contact, and it can be removed later without damaging the underlying factory trim when installed and removed correctly.

Suitable for

• Dashboard trim panels and center console surrounds
• Glove box fascias and small interior plastic covers
• Areas with light scratches, scuffs, or faded finish
• Owners who want a piano-black look without painting or replacing parts

Key specifications

• Finish: high-gloss piano-black
• Set composition: 4 pre-cut pieces tailored for Peugeot 508 interior panels (2010–2018)
• Material properties: thin, flexible film with pressure-sensitive adhesive backing
• Compatibility: designed to adhere to factory plastic and smooth trim surfaces found in the specified vehicle models
• Durability: resists light abrasion and daily wear when applied to clean, stable surfaces

How to use

Before application, clean the target surfaces thoroughly to remove dust, oils and silicone residues; a mild isopropyl alcohol wipe is recommended. Position each pre-cut piece over the corresponding trim area to confirm alignment, then peel the backing and apply the film progressively while smoothing out air bubbles with a soft squeegee or cloth. Apply heat gently with a heat gun or hair dryer at low setting to help the film conform to complex curves, keeping the heat source moving to avoid local overheating. Trim any excess material only where necessary and allow the adhesive to set for several hours before subjecting the surfaces to heavy use.

Usage recommendations

For best results, perform installation at room temperature and on surfaces that are dry and free from contaminants. Avoid aggressive solvents or abrasive cleaners on the film; clean with a soft microfiber cloth and mild soap solution. When removing the film, warm it gradually to soften the adhesive and peel slowly at a low angle to minimize residue; any remaining adhesive can be removed with a manufacturer-recommended adhesive remover applied sparingly.