Tint film GrizzGlass BodyShield for Opel Astra K Facelift (2019–2022) — black, set for pillar covers [4-in-1]

GrizzGlass BodyShield black tint film is designed specifically for the Opel Astra K Facelift (2019–2022). This 4-in-1 set contains pre-cut pieces for pillar covers that darken and protect the vehicle's A-, B- and C-pillars from UV exposure, minor scratches and everyday wear while maintaining clear outward visibility. The film is tailored to fit the pillar contours of the specified model and provides a uniform, low-reflective black finish that integrates with factory trim.

Advantages

The film delivers a consistent tint across pillar surfaces without altering window transparency or obstructing sightlines. It helps reduce UV penetration to interior surfaces and offers a thin protective layer against scuffs and light abrasions. Pre-cut pieces simplify alignment and reduce trimming time during installation. The material is formulated to adhere smoothly to curved pillar shapes and resist bubbling when applied correctly.

Suitable for

• Owners of Opel Astra K Facelift (2019–2022) seeking a coordinated pillar tint
• DIY installers wanting pre-cut, model-specific film pieces
• Detailers and fitters providing cosmetic protection for interior and exterior pillar areas
• Vehicles needing UV reduction and minor scratch protection on pillars

Key specifications

• Color: black (low-reflective)
• Configuration: 4-piece set for pillar covers (A-, B-, C-pillar coverage as applicable)
• Fit type: pre-cut, vehicle-specific contours for Opel Astra K Facelift (2019–2022)
• Primary functions: tinting, UV reduction, scratch and wear protection
• Surface finish: uniform matte/semi-matte finish to match trim

How to use

Clean the pillar surfaces thoroughly to remove dust, grease and residues before application. Position each pre-cut film piece over the corresponding pillar cover, aligning edges and contours. Use a spray solution recommended for tint film installation to allow repositioning, then squeegee from the center outward to expel air and moisture. Trim any minor excess only where necessary, and allow the adhesive to set following the manufacturer's drying time. For complex curves or tight areas, heat may be applied carefully to conform the film, taking care not to overheat painted surfaces or interior trim.

Usage recommendations

For best results, perform installation in a clean, dust-free environment at moderate temperatures. If unsure about fitment or heat-forming techniques, consider professional fitting to ensure smooth adhesion and long-term performance.