Window pillar film GrizzGlass BodyShield Black for Chery Tiggo 7 (2025–2026) set 10-in-1

GrizzGlass BodyShield Black for Chery Tiggo 7 (2025–2026) is a pre-cut set of pillar and window-post protective films designed to fit the door pillars and adjacent trim of the specified vehicle. The 10-in-1 kit supplies ten precisely shaped black film pieces that cover vulnerable painted and plastic surfaces around doors and windows. The film offers a uniform matte/low-gloss black appearance that helps harmonize trim finishes while protecting against everyday abrasion and cosmetic damage.

Advantages

The set reduces visible wear on pillars and window trim by providing a replaceable protective layer that resists scuffs and light scratches. Pre-cut pieces match factory contours to reduce trimming and installation time. The black finish standardizes the vehicle’s trim appearance and conceals minor imperfections. The film is thin and conformable, allowing it to adhere closely to curved and recessed areas without significantly changing panel fit or function.

Suitable for

• Protecting door pillars and window trim from scratches and scuffs
• Restoring a consistent black finish on mismatched or faded trim
• Reducing damage during daily entry and exit, loading, and cleaning
• Short cosmetic repairs where replacing panels would be unnecessary

Key specifications

• Kit composition: 10 pre-cut film pieces sized to fit Chery Tiggo 7 (2025–2026) pillars and adjacent trim
• Color and finish: black, low-gloss/matte appearance
• Material characteristics: thin, conformable protective film with adhesive backing for secure attachment
• Durability: designed to resist everyday abrasion and light surface scratches
• Surface compatibility: suitable for painted and plastic trim areas around doors and windows

How to use

Clean the target surfaces thoroughly to remove dirt, grease and wax; allow surfaces to dry completely. Position the corresponding pre-cut film piece on the pillar or trim to verify fit before peeling the backing. Peel the adhesive liner progressively while aligning the film to the contour, using a soft squeegee or cloth to smooth out air pockets and ensure full adhesion. For recessed or curved areas, apply firm, even pressure and warm the film lightly with a heat source if necessary to improve conformity. Trim any minor excess only if required and press all edges to secure the bond. Follow the same steps for each piece in the 10-in-1 kit.

Usage recommendations

Apply films at moderate ambient temperatures and on dry surfaces for optimal adhesion. Avoid washing or aggressive cleaning of treated areas for 24–48 hours after installation to allow the adhesive to cure. If removal is needed, heat the film edge and peel slowly to minimize residue; any remaining adhesive can be removed with an appropriate solvent safe for automotive paint and plastics.