Protective pillar film GrizzGlass BodyShield for Jetour X70 Plus (2025–2026) 2-in-1

GrizzGlass BodyShield protective pillar film for the Jetour X70 Plus (2025–2026) is a custom-cut 2-in-1 kit designed to protect exterior pillar surfaces from scratches, stone chips and general wear while preserving the original trim appearance. The film follows the contours of the vehicle's pillars and is formulated to be thin and virtually invisible after installation, helping maintain factory finish and resale value without altering the look of the car.

Advantages

This GrizzGlass BodyShield pillar film offers precise fit for Jetour X70 Plus models of the specified years, with adhesive backing engineered for outdoor durability and resistance to UV exposure. The material provides a balance of flexibility and toughness so it resists tearing and abrasions while conforming to curved surfaces. The two-piece kit simplifies coverage of multiple pillar sections and is intended for exterior use, enabling long-term protection without affecting paint or trim finish.

Suitable for

• Protecting A, B and C pillars on Jetour X70 Plus (2025–2026) from scratches and chips
• Preserving original trim appearance and factory paint condition
• Exterior pillar protection during daily driving and in urban environments
• Preparing a vehicle for long-term ownership or resale

Key specifications

• Kit type: 2-in-1 custom-cut pillar protection film
• Application area: exterior vehicle pillars (A/B/C as applicable)
• Material properties: thin, flexible, abrasion-resistant protective film
• Adhesive: permanent automotive-grade adhesive formulated for outdoor use and UV resistance
• Finish: low-visibility, preserves original trim and paint appearance
• Compatibility: specifically shaped for Jetour X70 Plus model years 2025–2026

How to use

Clean the pillar surfaces thoroughly to remove dirt, wax and oils before application; a lint-free cloth and isopropyl alcohol are recommended. Dry the area and align the film pieces against the pillar contours to verify fit. Slowly remove the backing and apply the film from one edge, smoothing with a soft squeegee or cloth to expel air and avoid wrinkles. If needed, use a heat gun or hair dryer on low setting to conform the film to complex curves, then re-squeegee to ensure full adhesion. Allow the adhesive to cure per ambient temperature guidelines before washing or exposing to heavy weather.

Usage recommendations

For best results, perform installation at moderate temperatures (ideally 15–25°C) on a shaded, dust-free surface. Avoid applying film on hot surfaces or in direct sunlight. If you are not confident in DIY installation, consider professional fitment to ensure seamless edges and optimal adhesion. Regularly inspect the edges and clean with mild soap and water to maintain clarity and durability.