Glass protective film GrizzGlass CeramicFilm for Virone VDP-60 intercom glass panel

GrizzGlass CeramicFilm for Virone VDP-60 intercom glass panel is a thin ceramic protective film specifically shaped for retrofit application on the Virone VDP-60 display. It provides a hard, transparent layer over the existing intercom glass surface to reduce visible scratches, repel dirt and guard against minor impacts while preserving the panel’s touch sensitivity and image clarity. The film is intended as a maintenance accessory to extend the usable life and maintain the appearance of installed Virone VDP-60 units without altering the underlying functionality.

Advantages

The ceramic construction delivers enhanced surface hardness compared with conventional PET films, increasing resistance to abrasion and scuffs while retaining optical transparency. The film’s low-profile design preserves touch responsiveness and does not interfere with capacitive or resistive touch inputs. Its oleophobic coating reduces fingerprint visibility and facilitates cleaning, and the film can be applied as a retrofit without replacement of the original screen assembly.

Suitable for

• Protecting Virone VDP-60 intercom display panels in residential or commercial door entry systems
• Maintaining touch performance while preventing cosmetic damage from daily use
• Retrofit upgrades for existing installations to extend display lifetime
• Environments where minor impacts, dirt and frequent touching occur

Key specifications

• Material: ceramic-based protective film with oleophobic coating
• Compatibility: shaped to fit Virone VDP-60 intercom glass panel
• Thickness: low-profile design to preserve touch sensitivity
• Optical clarity: high transparency to maintain display legibility
• Protection level: abrasion and scratch resistance, minor impact protection
• Surface finish: anti-fingerprint/oleophobic

How to use

Before application, clean the Virone VDP-60 glass surface thoroughly with a lint-free cloth and an appropriate screen-safe cleaner to remove dust, oils and residues. Align the CeramicFilm with the panel edges and apply from one side, smoothing across the surface to minimize air bubbles and ensure full adhesion. Use a soft squeegee or card wrapped in cloth to press the film down evenly; if small bubbles remain, they typically dissipate within 24–48 hours. Avoid powering the device off during installation unless required by the manufacturer’s safety guidance.

Usage recommendations

For best results, store the protective film in a clean, dust-free environment prior to installation and handle by the edges to prevent contamination. Clean the surface periodically with a soft microfiber cloth and non-abrasive cleaner. Replace the film if deep scratches, peeling or severe damage occur to maintain optimal protection and touch performance.