GTV motion sensor CR-2 CR-CR2000-10 1200W 220–240V 180° IP44 surface-mounted black

The GTV motion sensor CR-2 (CR-CR2000-10) is a surface-mounted presence detector designed to control lighting and electrical loads in residential and commercial environments. Rated for 220–240V supply and supporting loads up to 1200W, the device switches connected fixtures automatically when motion is detected across a 180° detection angle. With an IP44 rating, the sensor is splash-resistant and suited for indoor locations and sheltered outdoor installations such as covered entrances and corridors.

Advantages

The sensor provides reliable automatic switching for lighting circuits and other electrical loads up to 1200W, reducing manual operation. Its 180° detection field ensures broad coverage for hallways and entry zones, while the surface-mounted design allows straightforward installation on ceilings or walls. IP44 protection increases resistance to moisture and dust ingress in sheltered outdoor conditions. The black finish integrates with darker interiors and exterior fixtures where a discreet appearance is desired.

Suitable for

• Corridors, stairwells and internal passageways
• Entrance areas, porches and covered doorways
• Utility rooms, storage spaces and service areas
• Garages and sheltered outdoor lighting applications

Key specifications

• Supply voltage: 220–240V AC
• Maximum switched load: 1200W
• Detection angle: 180°
• Mounting type: surface-mounted (ceiling or wall)
• Protection rating: IP44 (splash-resistant)
• Colour: black

How to use

Mount the sensor on a stable surface at the recommended height, typically on a ceiling or wall overlooking the monitored area. Connect the device to the lighting circuit following local wiring regulations and ensure the supply voltage matches 220–240V. After power-up, adjust positioning to avoid obstructions that could block the 180° detection field. The unit will automatically switch connected loads on when motion is detected and off after the absence of movement according to its internal timing settings.

Usage recommendations

For reliable detection, install the sensor where movement crosses the detection zone rather than directly toward the sensor. Avoid mounting near heat sources, air conditioning vents or reflective surfaces that may trigger false detections. Use the device in sheltered outdoor locations only; it is not intended for unprotected exposure to heavy rain.