Dreame vacuums for fast and efficient cleaning!
In cart {{totalProductsCount}} item(s)
Your cart is empty
Memory Module HPE DDR2 2GB 667MHz ECC 1x2GB
The HPE DDR2 2GB 667MHz ECC memory module is a 240-pin DIMM designed for use in compatible HP Enterprise systems, workstations and legacy servers. With 2 GB of DDR2 DRAM running at 667 MHz and built-in ECC error correction, this module provides a straightforward capacity upgrade to improve multitasking and maintain data integrity in environments that support DDR2 memory and ECC functionality.
This 2 GB DDR2 DIMM combines error-correcting code (ECC) with a 667 MHz memory clock to reduce the risk of data corruption and increase system stability under sustained workloads. The module’s standard 240-pin form factor ensures compatibility with motherboards designed for DDR2 unbuffered DIMMs, while its 1.5 V operating voltage matches typical DDR2 power requirements, helping to maintain predictable power consumption and thermal characteristics.
Power down the system and disconnect it from the mains before installing the memory module. Open the system chassis according to the manufacturer’s instructions, locate an available DDR2 240-pin DIMM slot, and align the notch on the module with the slot key. Firmly press the module into the slot until the retention clips engage. After installation, reassemble the chassis, reconnect power, and boot the system. Verify that the BIOS or system firmware recognizes the new 2 GB module and that ECC functionality is enabled if required by the platform.
Install memory modules in matched pairs or according to the motherboard manufacturer’s guidance for optimal performance and compatibility. Ensure the target system supports DDR2 667 MHz and ECC; check the system manual for maximum supported memory capacity and slot population rules. Avoid mixing different voltages or memory types in the same system.
{{highlightedFeature.featureTitle}}:
{{getProductFeatureValueById(product, highlightedFeature.featureId)}}
{{ productComparisonGenerationError }}