Compression PEX to Female Thread Connector Hydroland PX-R.MG.25X1, 25 mm to 1" thread

Hydroland Compression PEX to Female Thread Connector PX-R.MG.25X1 is a mechanical coupling designed to join 25 mm PEX pipe to a 1" internal (female) threaded fitting. The connector provides a pressure-tight transition between flexible PEX distribution lines and threaded valves or fittings without the need for soldering or solvent welding. It is intended for potable water supply, heating circuits and for repair or extension work on PEX systems where a threaded connection is required.

Advantages

The compression design ensures a secure mechanical seal on 25 mm PEX pipe while offering compatibility with standard 1" female threaded components. Installation does not require heat, glues or special adhesives, which reduces installation time and eliminates the risks associated with open flame work. The connector provides a compact connection that maintains hydraulic integrity and supports common domestic plumbing and heating pressures when installed according to instructions.

Suitable for

• Connecting 25 mm PEX piping to 1" internal threaded valves and fittings
• Potable water distribution systems in residential and light commercial buildings
• Heating circuit connections and radiator or manifold interfaces
• Repairing or extending existing PEX installations where a threaded transition is needed

Key specifications

• Pipe connection type: compression for 25 mm PEX pipe
• Thread connection type: 1" internal (female) thread
• Material: corrosion-resistant metallic components suitable for plumbing use
• Connection method: mechanical compression (no soldering or solvents required)
• Typical applications: potable water and heating systems

How to use

Prepare the PEX pipe by cutting it squarely and deburring the end. Slide any required compression nut and ferrule components onto the pipe as applicable, insert the pipe fully into the connector body until it seats, then tighten the compression nut to the manufacturer’s recommended torque to form a watertight seal. Thread the connector onto the 1" internal fitting using appropriate thread sealant or tape if the receiving component requires it. After assembly, pressurize the system and check for leaks at the connection. Follow local plumbing codes and the connector manufacturer's installation guidelines for correct tightening and support of piping.

Usage recommendations

Use the connector only with compatible 25 mm PEX pipe and standard 1" female threaded fittings. Ensure threads are clean and use appropriate thread sealing material on the receiving fitting if required. Do not overtighten; observe recommended torque values and support adjacent piping to avoid stress on the joint. For potable water installations, verify material suitability and local regulations before use.