IBP elbow with unions 15 x 1/2" PG4471G0150400 for gas installations

IBP elbow with unions 15 x 1/2" PG4471G0150400 for gas installations is a compression 90° elbow designed for gas piping systems in domestic and light commercial settings. The fitting combines a compact elbow body with union connections to allow secure threaded joining and easier disassembly for maintenance or replacement. It is intended for use where a change of direction and a reliable seal are required in gas lines.

Advantages

The compression elbow provides a sealed connection without the need for welding, enabling straightforward installation on compatible metallic gas pipes. Union fittings at each end allow the elbow to be removed or replaced without disturbing long sections of piping, reducing downtime during maintenance. The compact 90° design saves space in tight installation locations and helps route gas lines cleanly through confined areas.

Suitable for

• Domestic gas supply lines in kitchens, boilers and meters
• Light commercial gas installations in small shops or service areas
• Situations requiring a 90° change of direction with serviceable connections
• Installations where future disassembly or component replacement is anticipated

Key specifications

• Connection type: compression elbow with union connections
• Size: 15 mm to 1/2 inch transition
• Angle: 90° elbow
• Material: suitable for metallic gas piping systems (manufacturer-specified metal)
• Application: for gas installations in domestic and light commercial use

How to use

Prepare the pipes by cutting square and removing burrs, then slide the compression nuts and rings onto the pipe ends. Insert the pipe ends into the elbow until seated, then tighten the union nuts according to the manufacturer's recommended torque to create a gas-tight seal. After assembly, perform a leak test using an approved method (soapy water or electronic gas leak detector) and follow local codes and safety procedures. If disassembly is required, loosen the union nuts and withdraw the elbow without cutting the run of pipe.

Usage recommendations

Install and service only by qualified personnel. Use the fitting only with compatible metallic gas pipes and in accordance with applicable gas installation standards and local regulations. Verify material compatibility and pressure ratings before installation, and always perform a post-installation leak test.